Hardening of the Grey Cast Iron through the Vibrating Electrode Method Using a WC Electrode and in Combination with TiC and Ti Electrode
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2008, Vol 31, Issue 1
Abstract
There have been tested samples of grey cast iron, the hardening being made through WC coating through the vibrating electrode method with a layer, two layers and through double layers combined with Ti and TiC. Besides double layers combined there were also made triple combined layers. Afterwards there were taken photographs of macro-hardness and HV50 micro-hardness into the material in into the layer. There were also made rugosity measurements. Then in order to appreciate the internal stresses were made ring specimens type Naimov. On the exterior of these specimens were made coatings with the vibrating electrode.
Authors and Affiliations
Manuela-Cristina PERJU, Carmen NEJNERU, Tudor RAILEANU, Mihai AXINTE, Ioan HOPULELE
Keywords
Related Articles
- EP ID EP659597
- DOI -
- Views 59
- Downloads 0
Study of the Sintering Process of Iron Powders Coated with Nano-Hydrocarbon and the Resulting Microstructure at Temperatures up to 1200 °C
The objective of the research is development and study of a new ecologically friendly and technologically advanced method for introduction of carbon during sintering of low alloyed iron powders ASC 100.29. The method is...
Surface Tension of Liquid Copper in Dilute Oxygen Concentrations
The studies of this paper regarding the influence of low oxygen contents on the liquid copper surface tension had as base „sessile drop” method and the determination of the oxygen content using calculation ratio where pa...
Experimental Investigation of Fatigue of Thin-Walled Welded Structures of Commercial Vehicle Frames
The fatigue behavior of bus frame components consisting of thin-walled tube beams joined together by fillet welding has been investigated. Numerical analysis by means of finite elements and experimental stress analysis b...
The Influence of the Thermomagnetic Treatments on the Hardness Number of Steels and the Superficial Layers Nitrided Durability
Two types of steels subjected to a nitriding thermo-chemical treatment after thermomagnetic treatments. The structural aspects into superficial layer of these steels are studied during friction process by using of an Ams...
Contribution of Heat and ThermoChemical Treatments to the Improvement of the Performances of High-Speed Steel Tools
The In this paper the influence of non-conventional heat and thermo chemical treatments upon the structure of tool steels and implicitly, upon the performances that are derived from applying such treatments, is presented...