IDENTIFICATION OF THE MASS INERTIA MOMENT IN AN ELECTROMECHANICAL SYSTEM BASED ON WAVELET–NEURAL METHOD
Journal Title: Applied Computer Science - Year 2018, Vol 14, Issue 2
Abstract
This paper presents the results of testing of a complex electromechanical system model. These results have been obtained for accepted in simu-lations the method of identifying an inertia moment of reduced masses on shaft of induction motor drive during the changes of a backlash zone width. The effectiveness of correct diagnostic conclusions enables coefficients anal-ysis of testing signals wavelet expansion as well as weights of a supervised learning neural network. The earlier fault detection of five important state variables, which describe physical quantities of chosen complex electro-mechanical system has been verified for its correctness during the backlash zone width monitoring in the early stage of its gradual rise. The proposed here algorithm with mass inertia moment changes has proved to be an effective diagnostic method in the area of system changeable dynamic conditions and this has been shown in the resulting changes of backlash zone width.
Authors and Affiliations
Marcin TOMCZYK, Barbara BOROWIK, Bohdan BOROWIK
Keywords
Related Articles
- EP ID EP560643
- DOI 10.23743/acs-2018-16
- Views 72
- Downloads 0
BOVW FOR CLASSIFICATION IN GEOMETRICS SHAPES
The classification of forms is a process used in various areas, to perform a classification based on the manipulation of shape contours it is necessary to extract certain common characteristics, it is proposed to use the...
NUMERICAL ANALYSIS OF THE DRAG COEFFICIENT OF A MOTORCYCLE HELMET
The paper discusses a numerical investigation, using a CFD tool, ANSYS FLUENT, of drag acting on a motorcycle helmet. The simulations were performed on a model of a helmet downloaded from a free CAD model library. A soli...
NUMERICAL SIMULATIONS OF SANDWICH STRUCTURES UNDER LATERAL COMPRESSION
The current paper analyzes the effect of the cross-section on the energy absorption capabilities of sandwich structures under compressive loads. For this purpose, several cross-section including triangular, square, hexag...
FINITE ELEMENT BASED PREDICTION OF DEFORMATION IN SHEET METAL FORMING PROCESS
In this paper the sheet forming process of cylindrical drawpieces was sim-ulated based on the finite element method by the explicit approach in the pres-ence of contact conditions with isotropic and anisotropic friction....
DETERMINATION OF RELATIVE LENGTHS OF BONE SEGMENTS OF THE DOMESTIC CAT'S LIMBS BASED ON THE DIGITAL IMAGE ANALYSIS
This paper is an introduction to the issues related to obtaining information on the metric dimensions of selected bone segments of a domestic cat based on the analysis of digital images. The main objective is to acquire...