Implementation of Close Loop Speed Control with VVVF Control and Slip Regulation on LIM
Journal Title: Engineering, Technology & Applied Science Research - Year 2014, Vol 4, Issue 2
Abstract
Open loop VVVF control has the disadvantage of low output torque when working at low frequency and poor speed precision at different load conditions.Various performance-improving schemes have been proposed for the basic VVVF control by compensating slips occurring in the low frequency range and slips caused by changing loads. Numerous papers have been published on the close loop speed control of rotary induction motor. In this paper a close loop speed control with VVVF control and slip regulation has been implemented for LIM based conveyor belt test Rig which compensates the disadvantages of traditional Volts/Hz control. SIMULINK results are presented to validate the effectiveness of proposed scheme.
Authors and Affiliations
K. Aditya, A. Newwel
Keywords
Related Articles
- EP ID EP90540
- DOI -
- Views 281
- Downloads 0
Improving the Bond Strength of Rice Husk Ash Concrete by Incorporating Polymer: A New Approach
This paper gives an insight of how to improve the bond strength of cement in which concrete is replaced with rice husk ash. A concrete mix was prepared and was used in different types of mixes i.e. Control Mix, 10% cemen...
Performance Analysis of Different Control Strategies in a Z-source Inverter
This paper presents the analysis for different control techniques in Z-source inverters. The voltage gain versus modulation index from simulation result is compared with the mathematical calculated voltage gain. Further...
Design of a Self-Phased Quadrifilar Helix Antenna for Satellite Communication
The objective of this study is the design and implementation of a Quadrifilar Helix Antenna (QHA) for telemetry, tracking and control of a Low Earth Orbit (LEO) satellite. Because of its cardioid-shaped circularly polari...
Numerical Simulation of Single-Phase and Two-Phase Flows in Separator Vessels with Inclined Half-Pipe Inlet Device Applied in Reciprocating Compressors
This paper aims to apply computational fluid dynamics (CFD) to simulate air flow and air flow with water droplets, as a reasonable hypothesis for real flows, in order to evaluate a vertical separator vessel with inclined...
Photoelastic Analysis of the Vertebral Fixation System Using Different Screws
The purpose of this study was to compare using photoelasticity, the internal stresses produced by two types of pedicular screws (Synthes™) with three different diameters, when submitted to different pullout strengths. Th...