INCREASING THE VALIDITY OF WALL CONSTRUCTION MATERIALS AFTER REPLACEMENT OF HYDROGENERATED LIQUIDS
Journal Title: Вісник Національного університету "Львівська політехніка". Серія "Теорія та практика будівництва" - Year 2018, Vol 0, Issue 904
Abstract
The results of the study of water absorption, compressive strength and bending strength, wetting angle of ceramic and cement-sand materials, impregnated with the production of SDP “Kremniypolimer” and developed mixtures of water-soluble liquids are presented in the article. The main hydrophobic materials produced by ZDP “KremnoiPolimer” for obtaining waterproofing liquids are 136-157 M; ETS-32; AKOR-B100. On the basis of GKZH-11N and GKZH-11K experimental waterproofing fluids No. 1 K, No. 2 K, No. 1 H and No. 2 Н were developed. Ceramic wall materials and cementitious and sand samples that simulate a mortar, impregnated with experimental mixtures (No. 1 K, No. 2 K, No. 1 N, No. 2 N), as well as AQUAFIN-F, have significantly lower water absorption, substantially increases their compressive and bending strength, while the marginal angle of wetting is significantly increasing. Similar results were obtained for hydro-insulating liquids ETS-32, AKOR B-100, microemulsions 136–157 M. It should be noted that ceramic specimens after impregnation have a slightly lower water absorption, somewhat higher compressive and bending strength and a more significant increase in the wetting angle compared to cementsand samples. From materials produced by ZDP “KremnoiPolimer”, somewhat better results were shown by ETS-32 and AKOR B-100 in comparison with the microemulsion 136–157 M. On the perimeter of the building, after pouring into pre-drilled holes of waterproofing liquids, a peculiar armopoy is created due to a significant increase in the strength of the wall materials on compression and bending.
Authors and Affiliations
Vasyl Iliv, Y. Iliv
Інвестиційний проект реконструкції каналізаційних очисних споруд та будівництва станції виробництва біогазу у м. Львові
This article describes the results of the technical and economic calculations and analysis of the economic efficiency of the project of reconstruction of waste water treatment plant. Lviv and construction of biogas plant...
NUMERICAL ANALYSIS OF STEEL FRAME SUBJECTED TO AIR BLAST
The paper focuses on the numerical analysis of steel frame subjected to air blast load. ABAQUS/Explicit was employed to establish 3D finite element model. Two-storey steel frame was discretized with solid elements. Air b...
МЕТОДИКА ДОСЛІДЖЕНЬ ЗАЛІЗОБЕТОННИХ БАЛОК З ПОШКОДЖЕННЯМИ, ОТРИМАНИМИ ЗА ДІЇ НАВАНТАЖЕННЯ
The research of reinforced concrete beams, in which there is some damage or defects are scare. This is especially applies to studies in which defects arise under the influence of the load, which is due to the complexity...
ДИСПЕРСНЕ АРМУВАННЯ СІРЧАНИХ БЕТОНІВ СКЛОВОЛОКНОМ ТА ЇХНЯ ВИТРИВАЛІСТЬ
Disperse reinforcing fibers of different materials and different lengths can significantly effect the basic characteristics of concrete, including increasing compressive strength and tensile, impact strength, wear resist...
Green roof as a saving technology and creator of microclimate
This paper highlights the importance of energy savings in terms of the best choice of vegetation used on green roofs. Kosice city is located in eastern Slovakia. Košice is situated on the Hornád River in the Košice Basin...