INDUCTION MAGNETOMETERS CONNECTION SCHEMES AND BASIC CALCULATION EXPRESSIONS
Journal Title: Вісник Національного університету "Львівська політехніка", серія "Радіоелектроніка та телекомунікації" - Year 2015, Vol 818, Issue 2015
Abstract
In article “Schemes of enabling and the basic calculated ratio of induction magnetometers (IM)” is considered the basic principle of IM operation and the basic scheme of it’s enabling. Analyzed frequency response of IM. The definition of IM sensitivity threshold is given in this article. Described the transfer function of IM. Analyzed the amplitudefrequency characteristic (AFC) of output voltage U0 in resonant mode. Described three ways of obtaining such AFC. Displayed the scheme and AFC with the current amplifier and equivalent circuit and AFC of IM with negative feedback on the magnetic field. Analyzed the AFC of IM. Presented noise signal scheme of IM with a feedback in the magnetic field and expressions of output voltage US, conversion factor of Gн(ω) and the phase shift of the voltage US relative to the measured magnetic field. Derived an equation for the frequency inflection, from which the expressions for the lower and upper frequency inflection was obtained. Presented the determine of sensitive threshold of IM and the physical meaning of sensitive threshold of IM. It is shown how the threshold is determined. Displayed the expression of resulting density of IM noise by it’s power WB and the expression of resulting density of IM noise in terms of measured magnetic field. To measure magnetic fields in applied geophysics, board space experiments, biomedical research, non-destructive testing and technical diagnostics in problems of electromagnetic compatibility and control side electromagnetic radiation devices and systems commonly used induction magnetometers (MI), which have very wide frequency range of effective application (from ~10-4 to ~106 Hz) and can measure magnetic fields in a large dynamic range (from fractions to tens of T) [1–6]. Their high sensitivity and ability to work in a wide frequency range combined with simplicity and high26 reliability and manufacturability explains the increased interest in these devices. The purpose of this work – to improve methods of calculating the transfer function of MI and their sensitivity threshold to improve IM settings used in geophysics.
Authors and Affiliations
Vitaliy Nichoha, Vira Pronenko, O. Saldan, I. Stefanyshyn
Keywords
Related Articles
- EP ID EP458072
- DOI -
- Views 137
- Downloads 0
THE METHOD OF QUALITY CONTROL OF PROCESSING INFORMATION FLOWS IN 5G NETWORK
The problems of functioning of quality assurance systems in the 5th generation mobile networks are discussed. The method of quality control of transmission of video streams in the 5th generation networks based Smart Grid...
ДО 70-РІЧЧЯ Ю. Я. БОБАЛА
Життєвий шлях Юрія Ярославовича Бобала є яскравим прикладом того, як обдарована, працьовита і цілеспрямована людина, віддана улюбленій справі, може досягти фахового успіху, стати відомим вченим і громадським діячем, здоб...
ALGORITHMIC SOFTWARE OF A TELEVISION SCANNING OPTICAL MICROSCOPE WORK IN THE STUDY OF DYNAMIC MICROOBJECTS
The questions concerning algorithmic software of the work of a television scanning optical microscope (TSOM) during research and determination of various parameters and characteristics of single and group dynamic microob...
SURFACE PLASMON-POLARITONS NANOSCALE WAVEGUIDES OBTAINED BY OPTICAL PHOTOLITHOGRAPHY
The paper presents a method of phased optical lithography using as source, lightemitting diodes (LED) with wavelengths of 410 nm and 365 nm to form inhomogeneous dielectric waveguides. Distribution of surface plasmon pol...
SPICE MODEL OF QUADRATURE SYNCHRONOUS DETECTORS FOR IMPEDANCE MEASURING TRANSDUCER
The task of impedance measurement transducers’ SPICE simulation is presented. Wide range of impedance spectroscopy microelectronic sensors, namely, for Internet of things, are based on such measurement transducers. One o...