INFLUENCE OF EROSIVE PARTICLES IMPACT ANGLE ON EROSIVE WEAR INTENSITY OF POLYURETHANE COATINGS
Journal Title: Tribologia - Year 2011, Vol 240, Issue 6
Abstract
The article presents examination results of the influence of alundum particle impact angle on the kinetics of the erosive wear of polyurethane coatings. Examined three-layer polyurethane coatings of an average thickness of 190 μm were examined. The average hardness acc. Buchholtz (PN-EN ISO 2815:2000) was 85, whereas the roughness parameters were Ra = 0.21 μm and Rz = 0.97 μm. The process of the erosive wear of coatings was investigated for impact angle α ranging from 25° to 75°. The erosive wear of the coatings was examined using the apparatus recommended by the Polish Standard PN-76/C-81516. The test specimen was mounted in a specially designed holder that allowed the precise setting of the angle of the specimen surface, which was subsequently subjected to testing. The apparatus enabled free fall of an abrasive material from 0.94 m height. As the abrasive material particles of granulated alundum of grain size 0.60–0.71 mm (acc. PN-76/M-59111) were applied. Examination that that the lower α angle, the higher the intensity of erosive wear of the polyurethane coating. For α angle equal 25°, due to the micro-cutting process domination, more intensive erosive wear was observed (I = 4.72 μm/kg) than in the case of impact angle values higher than 60°. However, the lowest intensity of erosive wear (I = 0.83 μm/kg) of the coating was observed for the impact angle α = 75° when deformative wear dominated.
Authors and Affiliations
Danuta Kotnarowska
Keywords
Related Articles
- EP ID EP270589
- DOI -
- Views 51
- Downloads 0
Kapryloamfoproponian sodu jako efektywny dodatek modyfikujący właściwości smarne wody
WEAR TESTING OF BUTTONS IN BITS FOR BLASTHOLE DRILLING
The article presents the results of the wear testing of buttons in selected types of bits with the diameter of 95 mm used for blast hole drilling in a rock mining. The purpose of the testing was to determine the type of...
ESTIMATION OF THE WEAR MECHANISM IN SLIDING CONTACT OF SATELITE GEARS OF A HYDRAULIC MOTOR
The paper presents tests of the wear of selected elements of a hydraulic satellite engine in sliding contact. The tests were carried out on the tribotester T-05 in a roll-block system, taking into account the influence o...
EFFECT OF THE SINTERING TEMPERATURE ON TRIBOLOGICAL WEAR OF 316L AND 316L-HAp OBTAINED WITH THE USE OF SPARK PLASMA SINTERING
The use of 316L stainless steel in osteoarticular system implants is associated with many operational problems. One of the methods that deal with these restrictions may be the development of new materials, including comp...
ANALYSIS OF ELASTICITY MODULUS AND MICROHARDNESS OF ENGINE PISTON SURFACE LAYERS IN THE ASPECT OF ITS WEAR
The paper presents the results of micro-hardness and Young's modulus measurements of the surface layers of selected surfaces of engine piston. Indentations were performed in the side, bottom, and the hub of the piston, i...