Influence of husbandry systems and thermal processing methods on the results of instrumental colour assessment and shear force of broiler chicken meat pl
Journal Title: Aparatura Badawcza i Dydaktycza - Year 2016, Vol 21, Issue 4
Abstract
The objective of the study was to assess the impact of raising systems and thermal processing methods on colour parameters and shear force. The study was conducted on the breast and leg muscles of Ross 308 broiler chickens from two different raising systems, with chickens from group A being held on littered indoor, while those in group B were on free-range with access to paddocks. The muscles were put through thermal processing, involving boiling (I) and baking (II) until the meat internal temperature achieved 820C. The influence of the raising system on the colour of the raw muscle was observed. It was found that both the breast and leg muscles of chickens held in free-range had characteristically darker colour, as evidenced by the significantly higher (p<0.05) colour saturation of red (a*) and yellow (b*). Lower mechanical resistance, measured by cutting force (p<0.05), had breast muscles (16.25 N) and leg muscles (19.21 N) from chickens kept without access to free-range compared to the breast muscles (14.37 N) and leg muscles (17.77 N ) from chickens with access to free-range. Raising system and thermal processing methods had impact on the varied colouration of the breast and leg muscles. Breast muscles from chickens held in indoor system but subjected to boiling processes were characterized by brighter colour. The thermal processing methods applied had significant impact (p<0.05) on the maximal shear force of the investigated muscles. Boiling muscles were characterized by lower shear force, which is better texture. It has been shown (p<0.05) the impact of the raising system on the value of the maximum shear force of breast muscles.
Authors and Affiliations
Anna Augustyńska-Prejsnar, Małgorzata Ormian, Zofia Sokołowicz
Keywords
Related Articles
- EP ID EP198745
- DOI -
- Views 96
- Downloads 0
Profil organicznych związków lotnych różnych rodzajów ściółek pochodzących z kurników zlokalizowanych w Polsce
Przedstawiono wyniki analizy profilu związków lotnych za pomocą GC/MS trzech rodzajów ściółek pochodzących z kurników w których utrzymywane są kury nioski. Zidentyfikowano 115 związków lotnych, 46 należało do grupy metab...
A new method and equipment for the detection of presence and estimation of the content of the petroleum-based fraction in lubricating oils, especially those emitted to the atmosphere
Lubricating oil, used in cutting equipment, works in the so-called open lubrication system and is entirely emitted to the environment. When such an oil contains even a small portion of the crude oil-derived fraction, whi...
Żywienie cietrzewi (Tetrao tetrix L.) w hodowli wolierowej
Przeprowadzono badania żywieniowe w warunkach sztucznej hodowli cietrzewi, w różnym okresie ich roz-woju osobniczego. Oparto się na obserwacjach własnych żerowania ptaków w terenie i informacjach z lite-ratury o ich natu...
Design and development of EMG controlled bionic prosthesis hand
This paper suggests a new approach to an EMG controlled prosthetic hand. The biomechanical, ergonomics, electrical/electronics, hardware/software aspects of the design are described in the article. The most important obj...
Stanowisko do badań modelowych przepływu powietrza w tunelu z wentylacją lutniową.
W pracy przedstawiono stanowisko służące do pomiaru pól prędkości powietrza w przypadku stosowania wentylacji lutniowej. Omówiono krótko zastosowanie tego typu wentylacji. Wyniki pomiarowe uzyskiwane na prezentowanym sta...