Influence of Technological Parameters on the Evolution of Nickel Films Deposited by Electrolysis
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2009, Vol 32, Issue 1
Abstract
The influence of technological parameters on the structure of nickel layers electrodeposited on a copper substrate in a Watts bath has been studied. The complex influence of current densities, temperature and pH values on the formation of the deposition layers are compared. The surface morphology of the nickel films was analyzed by scanning electron microscopy (SEM) and atomic force microscopy (AFM). X-ray diffraction (XRD) was used to investigate the crystallinity of the prepared samples. The increase in the current density leads to fine crystallized films, while layers obtained at even higher current density have dendritic structures. The temperature increasing results in a structure change from fine to coarse.
Authors and Affiliations
Maria POROCH–SERIŢAN, Gheorghe GUTT, Traian SEVERIN, Silviu STROE, Carmen MIHOC
An Analytical Procedure for the Prediction of the Stress-Strain State in Notches under Multiaxial Fatigue
This work presents an analytical procedure for estimating elastic-plastic stresses and strains in notched shafts subjected to synchronous non-proportional torsional and tensile cyclic loading. The specification of the eq...
Optimization of Thermomechanical Processing of Some Aluminum Alloys by Dimensional Interpolation Method Using the Matlab
This paper presents results of research on optimization of thermomechanical treatment applied to an alloy of the Al-Zn-Mg-Cu system, used in the aviation industry.Optimizing thermomechanical treatment process is based on...
The Pre-Biblical Metallurgical Art on the Biblical Territory
The Old Testament describes in detail the metallurgical achievements, both in the period before the conquest and colonization of the promised land (mostly related to the manufacturing of the Tabernacle, in this sense, th...
Study Regarding Gravimetrical Corrosion of the Superficial Layers Obtained through Electrical Discharge
The experimental research was made on superficial layers laid-down through electrical sparking on the steel carbon OLC 45 probes, the used electrode being made from a corrosion resistant material (Copper). The probes was...
A New Vision about the Dimensioning Calculus for the Frame of the Cold Mill Machine
Dimensioning calculus for a rolling mill machine frame, using resistance classical methods allows determines the introduction of errors .For to do a better precisely of calculus we propose to use “Finish Elements Method”...