Influence of the Wall Thickness Value on the Cross Wall Thickness Deviation of Tubes Rolled on the Tube Rolling Plant with the Continuous Mill
Journal Title: Журнал інженерних наук - Year 2018, Vol 5, Issue 1
Abstract
The high requirements as to accuracy of the wall thickness are due not only to necessity of assuring the reliability and serviceability of equipment, but also to the trend towards the continuous decrease of metal capacity. In this situation assuring observing of the given parameter is the most difficult affair. The cross wall thickness deviation can be presented in the form of two components: eccentric and symmetric deviation. In the given work authors present the research of the influence of the tube wall thickness on the share of eccentric component of the wall thickness deviation of the tubes rolled on the TRP with the continuous mill. Analysis of research results allowed concluding that with increase of the tube wall thickness the share of wall thickness deviation induced with the eccentricity decreases. On the whole, it is to be noted that for the giving plant, characteristically the influence of methods of longitudinal flaring (in continuous mill with mandrel and multistand mills of rolling without mandrel) on the tube accuracy is greater. In two first cases while reducing tubes to the finish dimension, the share of the number of faces, which depends on the summary reduction through the diameter and the value of tension, increases substantially.
Authors and Affiliations
S. V. Pilipenko, P. V. Drozhzha, E. A. Limonchenko
Keywords
Related Articles
- EP ID EP306837
- DOI 10.21272/jes.2018.5(1).a2
- Views 66
- Downloads 0
Investigation of produced waters radioactivity of oil and gas deposits in the Dnieper-Donets province
The process of radioactive pollution of produced waters, oilfield equipment, oil-contaminated soils and sludge is widely spread and differs within the various oil and gas regions. Formation waters contained radioactive e...
Analysis and development of the method for calculating calibration of the working plank in the cold tube roller rolling mills
In presented paper, which has for aim the development of existing method for calculating the profile of calibrated working plank in the cold tube roller rolling mills, the analysis had been made and it was proposed to us...
Mathematical Modeling of Gas-Cleaning Equipment with a Highly Developed Phase Contact Surface
The deposition of aerosols from process gas streams are the basis of many technologies in the chemical, petrochemical, coke, oil, gas, food etc. Industrial gases, containing aerosols of different nature of origin polydis...
Influence of an Inlet Rotating Axial Device on the Cavitation Processes in a Low Specific Speed Centrifugal Pump
The paper is devoted to the analysis of the cavitation processes in the flow section of the low specific speed centrifugal pump. A new conception of double-entry hermetic pump leads to the application of special shaped i...
Production of porous sintered materials using wastes of manufacturing engineering in self – propagating high-temperature synthesis
The increasing amount of wastes produced by the manufacturing engineering, as well as their physical and mechanical properties and restorability provide a search for sphere of their application. The actual problem of mod...