Influences of Aluminium / E-Glass Volume Fraction on Flexural and Impact Behaviour of GLARE Hybrid Composites
Journal Title: Журнал інженерних наук - Year 2019, Vol 6, Issue 1
Abstract
Composites with different configuration of fiber (E-Glass) and metal (Aluminium) laminates were fabricated and tested for grasping optimum hybrid structure. GLARE (Glass laminate aluminium reinforced epoxy) is a unique composite recently being used by wide engineering domains like defense body and vehicle armors, aerospace, marine and structural applications. The GLARE hybrid composites are manufactured by adding very thin layer of aluminium sheets (surface treated) on the surface of unidirectional E-Glass fiber fabrics in presence of epoxy polymer. Firstly three hybrid GLARE laminates were fabricated with different volume fractions. Consequently, impact and flexural behaviors are measured by izod, charpy impact and flexural tests for all volume configurations. Impact resistance of such hybrid laminate is intensively great. The results depicts that the linear metal volume fraction (MVF) increment on fiber metal laminates greatly increases impact energy absorption capacity of composites and little difference in flexural modulus. Finally the fractured surfaces were analyzed by optical microscope.
Authors and Affiliations
M. S. Santhosh, R. Sasikumar
Diamond Grinding the Ceramic Balls from Silicon Carbide
The influence of the machining regime was experimentally investigated on the output indexes of the diamond grinding the ceramic balls from silicon carbide, such as the rate of the material removal and the rate of changin...
Increased Wear Coatings due Intrastructural Self-Correction
A mechanism for blocking and subsequent annihilation of endogenous microcracks due to their intrastructural self-correction has been proposed. It has been established that during tribomechanical processes of friction int...
Optimum Choice of the Front Suspension of an Automobile
The paper details the optimum choice of the front suspension of an automobile. The influence of suspension on the steering geometry is studied by considering the various combinations of joints at the four-bar mechanism o...
Development of curvilinear blade impeller of vortex pump based on numerical simulation
The present paper focuses on study of relation between impeller outlet width and the slope of characteristic curve. In order to figure out this relation on the different operation modes the numerical simulation was used....
Alternative technology to manufacture bimetallic products by using self-propagating high temperature synthesis
Electric welding is usually used for surfacing metal products. This process may be laborious and timeconsuming, which at the same time excludes welding jointing throughout the product surface. The productivity of powder...