INVESTIGATION INTO THE CONDITIONS CAUSING TERMINAL-BOLTED TRACK GAUGE WIDENING AND CONSIDERATION OF IT IN THE CRITICAL GAUGE CALCULATION
Journal Title: Збірник наукових праць Українського державного університету залізничного транспорту - Year 2018, Vol 178, Issue 12
Abstract
In the current regulatory document UZ – Instructions for the device and the content Railways of Ukraine, the largest permissible value of track gauge – 1548mm, which was scientifically proved only for use as a sub-rail base wooden sleepers due to the possibility of the occurrence under certain conditions of falling of the wheels of the rolling stock, rails unfolding through the availability of pulling and screws. But, for tracks with concrete sleepers, rails unfolding not possible due to the hard bolt pressing pads to the sleepers and rails. In the presence on rails in the undocking way with reinforced concrete sleepers of the considerable sizes of lateral wear or corrosion damages of metal substrates in a zone of fastening of mortgage bolts, the certain value of dangerous width of a rail track is underestimated and economically inexpedient because of need of premature replacement of rail lashes. Therefore there is a need to clarify and justify the maximum allowable value of the width of a rail track with rail on the basis of concrete ties. To achieve this goal, it is necessary to conduct experimental studies with the worst real conditions of pressing the rails to the sleepers. The acute scientific task of determining maximum dangerous railway track gauge with reinforced concrete sleepers and fastenings of terminal-bolted track type has been set and solved on the base of the analysis of previous researches of leading scientists and scientific-research organizations of railway transport. Taking into account simultaneous actions of lateral force and track thrust force as well as all known tolerances and influences under the conditions of new maintenance profile of railway wheels of the most popular rolling stock, all the obtained results and recommendations have been differentiated according to the ranges of railway sections traffic volume and make it possible to increase running speeds and lifetime of long-welded rails substantially to use their service life to the maximum.
Authors and Affiliations
Vadim Novikov, Sergiy Panchenko, Olexiy Skoryk
Keywords
Related Articles
- EP ID EP378902
- DOI 10.18664/1994-7852. 178.2018.138626
- Views 59
- Downloads 0
DETERMINATION OF THE RATIONAL NUMBER OF SPEED PASSENGER TRAINS ON THE RAILWAY LINE
Construction of high-speed highways and the introduction of the rolling stock requires considerable investment. The existing transport network of Ukraine does not fully meet the requirements for the construction of high-...
CALCULATION FEATURES OF THE BIAXIAL BENT ELEMENTS USING THEIR STATE DIAGRAMS "MOMENT-CURVATURE"
Calculation features of biaxial bending reinforced concrete elements by the deformation-force model of their resistance are considered. Attention is focused on the disclosure of the internal static uncertainty of the cro...
INSPECTION OF MODERN BUILT-IN DEVICES FOR CONTROL AXLEBOX UNIT OF PASSENGER WAGONS FOR HIGH-SPEED TRAFFIC
The article defines the criteria for which it is necessary to evaluate and select the built-in monitoring tools. The review of modern built-in devices for monitoring the technical condition of the passenger compartment o...
ANALYSIS OF METHODS AND EXPERT EVALUATION OF OPERATIONAL CONTROL OF THE TECHNICAL STATE OF CHARGED PARTS OF MOBILE COMPOSITION
Classification of methods of diagnostics of wheel-sets of rolling stock is given. The systems of operative diagnosis by certain parameters and methods with the help of which wheel pairs are diagnosed, their advantages an...
THE INFLUENCE OF MULTICOMPONENT ADDITIVES ON EFFECTIVE VISCOSITY OF THE MECHANICALLY ACTIVATED CEMENT SUSPENSIONS
The questions of influence of prescription factors (microsilica, superplasticizer Super PK, polypropylene fiber) on changing of effective viscosity mechanical activated cement containing suspensions that are using in tec...