Investigation of critical frequencies of the centrifugal compressor rotor with taking into account stiffness of bearings and seals
Journal Title: Журнал інженерних наук - Year 2017, Vol 4, Issue 1
Abstract
In this paper the implementation of the mathematical model for rotor free oscillations of centrifugal machines is considered with the use of the computer program “Critical frequencies of the rotor”. The advantage of the program is the possibility of taking into account any advance given analytic dependence of support and seal stiffness on the rotor speed. As a result of numerical calculation on the example of the multistage centrifugal compressor 295GTS2-190/44-100M eigenfrequencies, critical frequencies and corresponding mode shapes are defined. The credibility of the proposed mathematical model is confirmed by theorem of the mutual position for spectrum of eigenfrequencies and correspondent critical frequencies, as well as by comparing the results of dynamic calculation in the program “Critical frequencies of the rotor” with the results of numerical simulation in ANSYS using the 3D finite element model and drawing the Campbell diagram.
Authors and Affiliations
I. Pavlenko, V. Simonovskiy, J. Pitel', A. Verbovyi, M. Demianenko
Keywords
Related Articles
- EP ID EP240039
- DOI -
- Views 117
- Downloads 0
Modelling of the vertical migration process of phosphogypsum components in the soil profile
This paper focuses on the study of the process of vertical migration of phosphogypsum components according to the soil profile. The qualitative and quantitative identification of main biogenic elements (phosphorus, sulph...
Solving the Nonstationary Problem of the Disperse Phase Concentration during the Pneumoclassification Process of Mechanical Mixtures
The article dials with studying of the gas-dispersed systems classification process in gravitation pneumoclassifiers of prismatic shape. The aim of the research is to determine operating parameters of the investigated pr...
Adjusting the size of the rope thread in the machining of dimensional tool
The article considers the possibility of adjustment the geometrical deviations profile rope thread with a large pitch, which appear as a consequence of wear of the cutting tool during machining. Due to the fact that the...
Application of Rough TOPSIS Technique for the Analysis of Engineering System Failure Causes
The prioritization of the causes of engineering system failure posed to be a challenge. Therefore, there is a need to develop a tool that will be used to identify critical problems of an engineering system to facilitate...
Polymeric compositional materials based on polycarbonate for units of devices for transform solar into thermal energy
Modern development of the industry is complicated without introduction of energy-saving technologies based on renewable natural energy sources. Solar and wind power plants, heat generators, solar collectors are wide spre...