Development of the method for estimating the inertia radius relative to the vertical axis of the car
Journal Title: Журнал інженерних наук - Year 2017, Vol 4, Issue 2
Abstract
The method of estimating the inertia radius relative to the vertical axis of the car is proposed. This allows a third to reduce the relative error of its definition. A refined formula for calculating the radius of inertia design with respect to the vertical axis of the car is proposed. The use of the proposed formula reduces the error of determining the radius of inertia from 21–27 % to 5 %, and the error of determining the inertia moment for the car from 46–61 % to 10 %. A method for assessing the adequacy of the results of theoretical and experimental studies is proposed. The use of the method has shown that the refined formula for calculating the radius of inertia relative to the vertical axis of the car makes it possible to reduce the probability of mismatching the results up to three times.
Authors and Affiliations
M. A. Podrigalo, A. I. Korobko, E. A. Dubinin, M. V. Baytzur
Keywords
Related Articles
- EP ID EP248377
- DOI 10.21272/jes.2017.4(2).h12
- Views 46
- Downloads 0
The decrease in technogenic load on the environment during the process of absorption of ammonia in soda industry
The article studies the effectiveness of implementation of existing equipment of soda production absorbers for ammonia cleaning from gas emissions. It identifies the major sources of ammonia emissions in the soda ash pro...
Influence of an Inlet Rotating Axial Device on the Cavitation Processes in a Low Specific Speed Centrifugal Pump
The paper is devoted to the analysis of the cavitation processes in the flow section of the low specific speed centrifugal pump. A new conception of double-entry hermetic pump leads to the application of special shaped i...
Development of curvilinear blade impeller of vortex pump based on numerical simulation
The present paper focuses on study of relation between impeller outlet width and the slope of characteristic curve. In order to figure out this relation on the different operation modes the numerical simulation was used....
Information-extremе machine learning for object identification on the terrain
The article deals with the usage of a SURF local descriptor of key fragments to create a global descriptor BoF for objects of interest on terrain within task of recognition of armored technique in the controlled territor...
Analysis of the gear tooth gearing by the module m = 2.625 mm of hydraulic pumps
The article deals with the method of finishing the cylindrical gears with diamond worm gear in mechanical engineering on a wide-universal milling machine. For processing, a special device has been developed, which provid...