Report on laboratory research of power-efficient triple-nozzle tuyere oxygen lancing
Journal Title: Журнал інженерних наук - Year 2017, Vol 4, Issue 1
Abstract
Based on the analysis of the advantages and shortcomings of the oxygen-converter production in Ukraine with combined oxygen and neutral gas blowing, a new combined-blowing technology by a threelevel lance has been proposed, which privedes the prolongation of the converter lining stability and a more efficient post-combustion of the exhaust gases with the prevention of local wear of the lining and intensive scraping of the lance body and the unit mouth. During the laboratory-industrial working-out of the proposed technology it was established that, depending on the level of the slag-metallic emulsion, two main post-combustion modes can be distinguished. The post-combustion process must be organized in such a way that the torches are within a half-diameter area of the outlet CO stream that prevents the torch's effect on the converter lining.
Authors and Affiliations
P. Yushkevich, L. Molchanov
Keywords
Related Articles
- EP ID EP240042
- DOI -
- Views 79
- Downloads 0
Mass transfer during sulfuric acid concentration by evaporation into the air flow
This article shows the results of the study of mass transfer under periodic concentration of sulfuric acid by evaporation inthe gas flow, neutral with respect to the components of acid. Used mathematical model for mass t...
Sulfur Utilization in the Systems of Biological Wastwater Denitrification
This paper focuses on the study of the possibility of using mineral carriers from sulfur (bio-sulfur/elementary sulfur) in anaerobic wastewater treatment systems under autotrophic denitrification conditions. The theoreti...
Optimization of controlled damages on the recognition in the master education
Information considered extreme learning algorithm is able to study decision support system as part of the automated control system combined heat and power unit with optimized control tolerances recognition. Within the fr...
Theoretical research of some parameters of contact area of wheel cutting surface and workpiece at flat face grinding with preliminary inclination of spindle axis
Theoretical researches that have made it possible to obtain the analytical dependences connecting the parameters of contact area of wheel cutting surface such as length, width, arc length, form deviation of flat surface...
Optimization of joint recycling process of drilling sludge and phosphogypsum
Joint recycling of drilling sludge and phosphogypsum with obtaining a building material is environmentally appropriate and cost-effective, as it helps not only to prevent environmental pollution, but also to solve the pr...