Investigation of Electrochemical and Morphological Properties of Mixed Matrix Polysulfone-Silica Anion Exchange Membrane
Journal Title: Journal of Engineering and Technological Sciences - Year 2016, Vol 48, Issue 1
Abstract
Mixed matrix anion exchange membranes (AEMs) were synthesized using dry-wet phase inversion. The casting solutions were prepared by dispersing finely ground anion-exchange resin particles in N,N-dimethylacetamide (DMAc) solutions of polysulfone (PSf). Subsequently, nanosilica particles were introduced into the membranes. The results show that evaporation time (tev) and solution composition contributed to membrane properties formation. A longer tev produces membranes with reduced void fraction inside the membranes, thus the amount of water adsorbed and membrane conductivity are reduced. Meanwhile, the permselectivity was improved by increasing tev, since a longer tev produces membranes with a narrower channel for ion migration and more effective Donnan exclusion. The incorporation of 0.5 %-wt nanosilica particles into the polymer matrix led to conductivity improvement (from 2.27 to 3.41 mS.cm-1). This may be associated with additional pathway formation by hydroxyl groups on the silica surface that entraps water and assists ion migration. However, at further silica loading (1.0 and 1.5 %-wt), these properties decreased (to 1.9 and 1.4 mS.cm-1 respectively), which attributed to inaccessibility of ion-exchange functional groups due to membrane compactness. It was found from the results that nanosilica contributes to membrane formation (increases casting solution viscosity then reduces void fraction) and membrane functional group addition (provides hydroxyl groups).
Authors and Affiliations
I Gede Wenten, Khoiruddin Khoiruddin
Keywords
Related Articles
- EP ID EP203730
- DOI 10.5614/j.eng.technol.sci.2016.48.1.1
- Views 158
- Downloads 0
Evaluation of the Fate of Nitrate and Analysis of Shallow Soil Water using Geo-electrical Resistivity Survey
Evaluation of the fate of nitrate and analysis of shallow soil water in a tobacco plantation area were conducted using integration of soil properties and hydrogeochemical analysis, and geo-electrical resistivity methods,...
Study of Micro-hardness of High-Speed W9Mo4Co8 Steel Plates in Pendulum Grinding by Abrasive Wheel Periphery
In cutting tool assembly, grinding is the most important technological step of the finishing treatment, largely determining the workmanship. An increase of micro-hardness after grinding relative to the original one indic...
Synthesis of Acrolein from Glycerol Using FePO4 Catalyst in Liquid Phase Dehydration
Acrolein is currently produced using propylene from crude oil while its price and scarcity are increasing. A renewable material such as glycerol is an attractive alternative for acrolein production. It can be obtained fr...
Liquefaction Potential Analysis Along Coastal Area of Bengkulu Province due to the 2007 Mw 8.6 Bengkulu Earthquake
This paper presents a seismic response analysis study of liquefiable sites along the northern parts of the coastal area of Bengkulu Province that underwent liquefaction phenomena during the strong earthquake (8.6 Mw) on...
Tectonics and Geological Factors Controlling Cleat Development in the Barito Basin, Indonesia
Cleats are natural fractures within coal seams. This paper presents the results of regional cleat mapping and characterization in relation to coalbed methane (CBM) exploration and development in the Barito Basin, South K...