Investigation of Single Bolted Connections of Thin Wall U Steel Profiles with Eccentric Behaviour
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2019, Vol 7, Issue 2
Abstract
There is no Turkish standard for bolted connections of thin walled steel elements. In the calculations made according to Eurocode and AISI standards, there are different approaches and behaviours for the same sample. The eccentric effect was ignored in the experimental studies obtained in the literature review and only the behaviour under axial stress was examined. In practice, however, it is not possible to avoid eccentric behaviour arising from the profile structure. The eccentric behaviour created by applying the pulling force applied from the centre of gravity of thin walled U profiles placed on back to back is compared with the strengths obtained from the equations given in the relevant standards under various sheet metal thicknesses (t=1,5mm, 2mm, 2,5mm) and various bolt diameters. (Ø=8mm, 10mm, 12mm)
Authors and Affiliations
Yusuf DEMİREL, Oğuzhan TÜYLÜOĞLU
Keywords
Related Articles
- EP ID EP603533
- DOI 10.29109/gujsc.545509
- Views 106
- Downloads 0
The Definition and Prediction of Stress Analysis of Plates with Elliptic Hole by Artificial Neural Networks
In this study, maximum tensile stress values on plates with elliptic hole which are exposed to tensile strength have been calculated. These calculations have been modelled by Artificial Neural Networks (ANN). Besides, fi...
A comparative study and a proposal of a decision support system for the pull systems
Pull system is a production approach that material movement is triggered by a signal. Although the pull system is usually used as a synonym of kanban system, it has been seen that kanban does not work well in some produc...
Investigation of Parameter Estimation Methods for Wind Energy Potential Calculation
Weibul distribution is widely used to compute wind power potential. There are a lot of estimation methods about Weibull distribution’s parameters in literature. But L-moment estimation method is rarely used to compute wi...
The Effects of Shot Peening parameters on the subsurface properties of AA7075 T6 aluminum alloy
Shot peening (SP) is an important mechanical surface treatment widely used to improve the fatigue life of mechanical components operating under dynamic loads which have been specifically used in automotive and aerospace...
Measurement of Emission Reduction Which Depend on Trip Change by Modelling with Park and Ride System in Ankara
Park and Ride Systems (P+R) are transfer systems which are located around the city and near the city center that encourage individuals from using passenger cars to public transport to minimize the use of passenger cars d...