Investigation of the Effect of Using Biodiesel Diesel Engine Fuel System Injectors
Journal Title: International Journal of Automotive Engineering and Technologies - Year 2013, Vol 2, Issue 1
Abstract
In this study, currently used as a fuel in diesel engines instead of diesel fuel, biodiesel from renewable energy sources is used, the mass loss due to wear of diesel engines, injectors, injector opening pressure of diameter shrinkage and as a result, the fuel density and changes in the system flows is investigated Research, a diesel engine, electric motor, for a period of 1000 hours with the motion given to biodiesel, the fuel system was built cycle. At the end of this study, caused by wear, 0,08333 to 0,13893% reduction in diameter of the injector needle, syringe needle bodies decreased from 0,00810 to 0,01494%, 0,00848 to 0,02084% loss in mass bodies injector nozzle, injector opening reduction of 3-5bars pressure and fuel flow volume 0,46 mL/h was observed to be reduced.
Authors and Affiliations
Sait ARAS*| Technical and Industrial Vocational High School 42003 Selçuklu / KONYA, Necmettin TARAKÇIOĞLU| Selçuk University, Faculty of Technology 42031 Selçuklu / KONYA
Keywords
Related Articles
- EP ID EP3871
- DOI -
- Views 509
- Downloads 30
Experimental Study on Combustion Duration and Performance Characteristics of a Hydrogen-Ethanol Dual Fueled Engine
This paper discusses the results of combustion duration and performance characteristics of a hydrogen-ethanol dual fueled engine. The tests were conducted on a compression ignition engine (modified to run on spark igniti...
Car Seat Comfort by Measuring Interface Pressure and Using Subjective Evaluation System in Road Trials
This study assesses automobile seat comfort by using a subjective evaluation system with road trials and by measuring seat pressure. The focus of this study is to demonstrate how drivers are affected by seat comfort unde...
The Simulation of a Full Electric Vehicle Using the City Cycle
In this present study, the design and simulation of an electric vehicle again commonly being started to be used in twenty-first century have been carried out by Matlab program. A full-electric vehicle has been used as a...
Drag Force Estimation of a Truck Trailer Model Using Artificial Neural Network
Prediction of the drag forces acting on a truck trailer with/without spoiler is carried out by using artificial neural network (ANN). ANN model data set include the experiments of spoiler positions which have zero level...
Modeling and Predicting of Tribological Behaviour of the Automotive Brake Pad Using Response Surface Methodology
In the present study, wear and frictional behaviours of automotive brake pad sliding against GG 20 cast iron counter face have been investigated experimentally using a pin on disc type friction tester. Wear tests were ca...