LABORATORY INVESTIGATIONS OF WEAR RESISTANCE UNDER FRICTION OF A SURFACE LAYER OF 41CrAlMo7 STEEL AFTER GLOW DISCHARGE NITRIDING AS WELL AS ABLATION LASER TEXTURING
Journal Title: Tribologia - Year 2013, Vol 249, Issue 3
Abstract
The paper presents the results of laboratory investigations including measurements of selected parameters in the node of friction (temperature, friction force, wear resistance) with the use of the measured line method for the surface layer of samples steel 41CrAlMo7 after nitriding and laser texturing in combination with cast iron samples. Surface layers after glow discharge nitriding steel were modified using ablative laser micromachining to change its macro- and micro-geometry. In the manufacture regular shaped oil micro-channels and spherical microparticles, we used a Nd: YAG laser with a special focusing system. Comparative research has been subjected to the steel surface topography formed by conventional machining and plasma nitriding and modified after nitriding and laser ablation micromachining. The laboratory tribological investigation used the "pin on disc" method based on a T-11 tribometer. The best results of increasing wear resistance under friction was obtained for the association sample made of steel 41CrAlMo7 after glow discharge nitriding and ablative laser texturing in the geometric arrangement mico-oil containers (micro spherical cap) with a degree of covering of about 25% worked with cast iron anti-samples.
Authors and Affiliations
Wojciech Napadłek, Czesław Pakowski, Adam Woźniak
Keywords
Related Articles
- EP ID EP270337
- DOI -
- Views 57
- Downloads 0
TEMPERATURE OF THE TOP LEVEL SURFACE OF PARTS OF AGRICULTURAL SOIL TILLING MACHINERY. PART II – THERMOVISION MEASUREMENTS
Using a thermal camera, the temperature distribution of the surfaces of ploughshares, subsoil shanks, and cultivator tooth coulters was determined. These parts worked in soil conditions during operation in the field. The...
WPŁYW KĄTA ODDZIAŁYWANIA GLEBOWEJ MASY ŚCIERNEJ NA INTENSYWNOŚĆ ZUŻYCIA STALI
W artykule przedstawiono badanie wpływu kąta natarcia powierzchni roboczej próbki wykonanej ze stali Hardox Extreme na intensywność zużycia ściernego. Badania prowadzono metodą wirującej misy w dwóch rodzajach glebowej m...
THE CORROSION INFLUENCE ON USING OF METAL MATRIX COMPOSITES BRAKE DISCS
In this article an influence of corrosion on tribologial properties of composite material F3S.20S (A359+20%mSiC) mated with material used in production of brake pads (F701) has been studied. In order to define the influe...
DEVICE FOR TESTING THE WEAR RESISTANCE OF MATERIALS FOR PARTS OF FOIL BEARINGS
The paper presents a tribological test device for testing the wear resistance of materials used in foil bearings used in microturbines operating in combined heat and power plants in an organic Rankine cycle (ORC) with lo...
TRIBOLOGICAL PROPERTIES OF TI/A-C:H NANOCOMPOSITE CARBON BASED COATINGS
The paper presents the results of mechanical and tribological tests of Ti/a-C:H nanocomposite carbon coatings and a-C:H hydrogenated carbon coating. All coatings were deposited by magnetron sputtering technique at variou...