LABORATORY TESTS OF THE USE OF BELT CONVEYOR ELEMENTS FOR MOULDING SANDS
Journal Title: Tribologia - Year 2018, Vol 281, Issue 5
Abstract
The article presents the results of research on the wear of belt conveyors’ elements made of various materials. For the purpose of the experiment, a test stand was built, reflecting the real working conditions of the conveyor belt, on which abrasive tests of samples made of appropriately selected materials and a control sample of steel were carried out. Obtained wear values indicated the most wear-resistant material.<br/><br/>
Authors and Affiliations
Dawid ROMEK, Jarosław SELECH, Michał BERDYCHOWSKI, Włodzimierz KĘSKA
Keywords
Related Articles
- EP ID EP417511
- DOI 10.5604/01.3001.0012.7658
- Views 41
- Downloads 0
METODA I URZĄDZENIE DO WYSOKOTEMPERATUROWYCH BADAŃ TRIBOLOGICZNYCH WŁAŚCIWOŚCI ŚRODKÓW SMAROWYCH
W opracowaniu przedstawiono urządzenie do badania tribologicznych właściwości smarów plastycznych przeznaczonych do pracy w podwyższonych temperaturach przy niskich wartościach obciążenia. Jest to urządzenie opracowane w...
SURFACE GEOMETRIC STRUCTURE CREATED BY THE ELECTRICAL DISCHARGE MACHINING PROCESS
Electrical discharge machining, which belongs to the non-conventional group of machining methods is widely used for manufacturing elements made of hard materials and those having a complicated geometry. The paper gives a...
PRELIMINARY EXPERIMENTAL RESEARCH OF TRIBOLOGICAL PROPERTIES OF BUS BRAKES FRICTION LININGS
Experience gained from the use of buses in urban conditions showed that the working conditions of friction elements of the braking system, ensuring traffic safety, are associated with high loads. This leads to the intens...
Capacity enhancement with friction force diminution in HDD spherical micro-bearing
This paper presents the new methods of friction force calculations occurring in slide hydrodynamic HDD micro-bearings with spherical journals. Moreover the paper presents new ideas for calculation and design of slide hyd...
MODIFICATION OF THE SURFACE LAYER OF SINTERED DUPLEX STAINLESS STEELS THROUGH ALLOYING USING THE GTAW METHOD
The demand for materials obtained using powder metallurgy (PM) is constantly increasing, especially on SDSSs, which are characterized by a two–phase structure consisting of ferrite and austenite. The main purpose of this...