Large Scale Industrial Temperature Monitoring and Control System using LABVIEW through USB (MANUAL AND AUTOMATIC Modes)
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2018, Vol 13, Issue 2
Abstract
The temperature monitoring and control system can be done in computer (PC) using Laboratory Virtual Instrumentation Engineering Workbench (LABVIEW) software. To obtain the quality of service in the industries, data acquisition plays an important role. The main purpose of using LABVIEW is for data acquisition. The temperature is measured by the temperature sensor (LM-35) and the obtained analog signal is processed by the microcontroller (LPC-1768). The LABVIEW acquires data from the microcontroller through USB port for further processing of the data. The data is processed and displayed in the LABVIEW. The system control and automation can be done through the help of control circuitry in the LABVIEW. There are two modes, “automatic” and “manual”, in which either one can be selected in the LABVIEW. The temperature values obtained can be stored into the excel sheet through the LABVIEW.
Authors and Affiliations
Balla Pavan Kumar
Keywords
Related Articles
- EP ID EP388728
- DOI 10.9790/1676-1302038388.
- Views 151
- Downloads 0
Proportional-Integral with filtered Integral mode Controller using Krill Herd (KH) algorithm in a Restructured Power System with HES and IPFC Units
This paper presents the design methodology using Proportional and Integral plus (PI+ ) controllers and Proportional-Integral (PI) with Filtered Integral (PIFI) mode controller for the Automatic Generation Control (AGC) o...
Theory and Analysis of Three Phase Induction Motor using Written Pole Technology
Three phase induction motors are employed in almost all the industries because of its simple construction and easy operation. Efficiency of the induction motor is affected by its fixed losses and variable losses which ma...
Unmanned Coastal Monitoringandpropulsion System
The International Maritime organization (IMO) sets regulations for marine vessels to insure safety and prompt response to various demands. when it comes to an unmanned vessel it has been done with PID controllers in whic...
Power Quality Improvement By Usingstatcom To Grid Connected Wind Energy System
Now a days the electrical energy is basic necessary of all over world. Due to generation, transmission and utilization of wind energy system is affected the voltage variation, flicker, harmonics, and electrical behavior...
A Review of Maximum Power Point Tracking Algorithm for Solar Photovoltaic Applications
The world’s large dependency on conventional energy sources has not only posed a threat to the environment but also they are non-renewable. Therefore, a huge interest is put upon renewable sources of energy. Amongst them...