MATERIALS AND TECHNOLOGICAL DEVELOPEMENT OF SCREEN PRINTING IN TRANSPORTATION
Journal Title: INTERNATIONAL JOURNAL FOR TRAFFIC AND TRANSPORT ENGINEERING - Year 2012, Vol 2, Issue 2
Abstract
Screen printing is a widely used technology in electronic technology. Even though there were many developments in the technology, it is still being under improvement. This paper deals with the automotive industry related screen printing processes. The processes associated with layer deposition and the manufacturing process parameters, which affect the quality of the prints. As the repair of electronic control unit (ECU) used in road vehicles is nearly impossible the quality of printing therefore unquestionable. It is very important that the accidents caused by mechanical failure must be kept as low as possible therefore the avoidance of failure in screen printing is not only economical question but in case of transportation it is also question of road safety. Finally, an overview is given of the typical failure effect and possible causes appearing in screen printing.
Authors and Affiliations
Eszter Horvath, Gabor Henap
Keywords
Related Articles
- EP ID EP130080
- DOI -
- Views 114
- Downloads 0
MARKET MULTIPLES ADJUSTMENTS FOR DIFFERENCES IN RISK PROFILE – AN AIRLINE COMPANY EXAMPLE
Companies whose data can be found in databases usually are not comparable enough to the valuation subject to assure direct use of their multiples (i.e. to assure reliability of valuation resulting from direct use of thei...
PREVAILING SATURATION FLOW RATE FOR LANE GROUPS IN AN URBAN AREA
This study focused on determining the prevailing Saturation Flow Rate (SFR) for specific lane groups in an urban area: District of Columbia (DC). The lane groups considered were Through (T), shared Through and Right (TR)...
EVALUATION OF THE EFFECT OF VMS IN REDUCING CONGESTION USING AIMSUN TOOL: A CASE STUDY OF ARTERIAL ROAD NETWORKS WITHIN THE CBD OF KADUNA
Microscopic simulation of traffic on the road network within the CBD of Kaduna in Nigeria (10°31’23’’N and 7°26’25’’E) was carried out using AIMSUN tool to investigate the extent to which variable message signs (VMS) dis...
DEVELOPMENT AND EVALUATION OF A PROTOTYPE BARRICADE LIGHTING SYSTEM
Presently in work zones, standard barricade warning lights are used to provide channelizing and warning functions. These yellow flashing lights are presently used for different work zone activities. Concepts for a non-st...
INVESTIGATION OF THE EFFECT OF TRAFFIC PARAMETERS ON ROAD HAZARD USING CLASSIFICATION TREE MODEL
This paper presents a method for the identification of hazardous situations on the freeways. For this study, about 18 km long section of Eastern Freeway in Melbourne, Australia was selected as a test bed. Three categorie...