Mathematical Modeling of the Mechanical Characteristic of the Activated PTFE-Matrix Using the Method of Planning the Experiment
Journal Title: Журнал інженерних наук - Year 2018, Vol 5, Issue 1
Abstract
In this paper, the influence of the parameters of the technological process of mechanical activation on the physical characteristics of the polytetrafluoroethylene (PTFE) matrix is investigated. The paper presents a mathematical model of the dependence of breaking strength on the time of activation and rotating speed of working organs of a mill. Mathematical modeling is performed by the method of orthogonal experiment planning. The result of the study was a mathematical relation that explains the connection between the technical characteristics of the process of manufacturing a fluoroplastic composite and the mechanical characteristics of the material. The statistical analysis of the experimental results is performed and the adequacy of the mathematical relations obtained is estimated. On the basis of the analysis of the obtained data, it can be concluded that the theoretical model obtained is adequate and suitable for performing the corresponding technological calculations. On the basis of the performed calculations, the conclusion is reached on the optimal technological mode of preparing the PTFE-matrix. The analysis shows that theoretical calculations confirm the experimental value of technological indicators under optimal operating conditions of the mill. Thus, the obtained dependence of breaking strength from the technological parameters of the activation process can be embedded in the algorithm for selecting the technological mode that ensures the output of products with specified quality indicators.
Authors and Affiliations
O. A. Bilous, T. P. Hovorun, K. V. Berladir, S. I. Vorobiov, Simkulet V. V.
Keywords
Related Articles
- EP ID EP306889
- DOI 10.21272/jes.2018.5(1).c1
- Views 87
- Downloads 0
Spline shaft hob cutter accuracy increase by the means of theoretical profile approximation by the circle involute section
One of the most wide spread and efficient spline shafts manufacturing methods is their cutting by the means of generating process by hob cutters. In this case, hob cutter’s theoretical profile, taking in to account its i...
The decrease in technogenic load on the environment during the process of absorption of ammonia in soda industry
The article studies the effectiveness of implementation of existing equipment of soda production absorbers for ammonia cleaning from gas emissions. It identifies the major sources of ammonia emissions in the soda ash pro...
Polymeric compositional materials based on polycarbonate for units of devices for transform solar into thermal energy
Modern development of the industry is complicated without introduction of energy-saving technologies based on renewable natural energy sources. Solar and wind power plants, heat generators, solar collectors are wide spre...
Microstructure and Properties of AlCrFeCoNiCux High-Entropy Alloys
The peculiarities of the structure formation of alloys of the system AlCrFeCoNiCuх (where x = 0, 0.5, 1, 2, and 3 moles) were studied. Durometric studies of alloys of this system were carried out. Established that an all...
Selection of the Optimal Software for Designing Expert Systems
This article deals with the problems of information processing, searching and finding the solutions in the related fields of scientific knowledge. One of the solutions to this kind of problem is the software like expert...