Polymeric compositional materials based on polycarbonate for units of devices for transform solar into thermal energy
Journal Title: Журнал інженерних наук - Year 2017, Vol 4, Issue 1
Abstract
Modern development of the industry is complicated without introduction of energy-saving technologies based on renewable natural energy sources. Solar and wind power plants, heat generators, solar collectors are wide spread in developed countries. One of it is device for transform solar into thermal energy. It is costly devices with low level of reliability and durability. Therefore actual tasks of this work are reduction cost of device for transform solar into thermal energy and increase it level of reliability and durability. These tasks are carried out by the way of substitution the main elements of device for transform solar into thermal energy by development polymeric compositional materials (PCM). As the polymer matrix is selected polycarbonate. This matrix is modified by silicon rubber and filled by graphite. The silicon rubber increase technological effectiveness by procedure of obtaining PCM. Graphite significantly increase tribotechnical properties of PCM in friction units with steel. Developed PCM can be recommended for application in main elements of device for transform solar into thermal energy, that lead to increasing of it level of reliability and durability.
Authors and Affiliations
V. Sytar, K. Sukhyy, O. Kabat, I. Nachovnyi
Keywords
Related Articles
- EP ID EP240045
- DOI -
- Views 81
- Downloads 0
Optimum Choice of the Front Suspension of an Automobile
The paper details the optimum choice of the front suspension of an automobile. The influence of suspension on the steering geometry is studied by considering the various combinations of joints at the four-bar mechanism o...
Special aspects of machining of internal threads by measure tool
Based on an analysis of recent studies of various machining methods the disadvantages of existing methods of internal threads machining have been identified. The proposed method of machining round threads by up to measur...
Influence of the Wall Thickness Value on the Cross Wall Thickness Deviation of Tubes Rolled on the Tube Rolling Plant with the Continuous Mill
The high requirements as to accuracy of the wall thickness are due not only to necessity of assuring the reliability and serviceability of equipment, but also to the trend towards the continuous decrease of metal capacit...
Microstructure and Properties of AlCrFeCoNiCux High-Entropy Alloys
The peculiarities of the structure formation of alloys of the system AlCrFeCoNiCuх (where x = 0, 0.5, 1, 2, and 3 moles) were studied. Durometric studies of alloys of this system were carried out. Established that an all...
The impact of multi-gap seals on rotor dynamics
The research relevance of multi-slotted seals is of practical significance for increasing vibration-reliability of centrifugal pumps. This paper presents the model of a single-disk rotor with seals. The forced radial rot...