Measurement and Analysis of Deformation Shapes on Corrugated Cardboard Logistical Boxes Under Static and Dynamic Compression
Journal Title: Acta Technica Jaurinensis - Year 2015, Vol 8, Issue 4
Abstract
On the field of compression strength of packaging the researchers, studies and standards mainly focus on the short-time measurements. The derived results from these accelerated tests can be used with a large tolerance in reality. These measurements do not give response that how long the packaging is able to tolerate the given calculated or measured stress during a long-term storage in the supply chain without damages in the aspect of product or packaging. The tests in this paper were done to analyse the possible deformation shapes, which could be a first step into the process of final damage. The samples were tested under both static and dynamic compression. The deformations were observed by TRITOP system in order to prove the different deformation processes between the static and dynamic compression. This paper is a first phase of a research program, which deals with the effect of real compression and physical environment of logistics boxes on long time storage and stacking.
Authors and Affiliations
P. Böröcz
Keywords
Related Articles
- EP ID EP630748
- DOI 10.14513/actatechjaur.v8.n4.389
- Views 198
- Downloads 0
System Approach for Strategic Planning in Transport
The paper gives an overview on the current status of the connection between city and transport. After a short theoretical introduction on the effect of different city development strategies it shows the importance of tra...
Parallel Numerical Creation of 2-parametric Bifurcation Diagram of Nonlinear Oscillators
This paper presents the numerical creation of 2-parametric bifurcation diagrams of nonlinear oscillators with a simple iterative algorithm, which can be easily parallelized. The parallel algorithm was tested with two sim...
A Method for the Numerical Modelling of Embedded Rails and Determining Parameters to be Optimized
To carry out FEM modelling two model parameters are needed the elastic (Young) modulus (E) and the Poisson-coefficient (μ). Unfortunately, they are not available in every case, and even if so, they need to be corrected....
Decision Support Model to Select Cushioning Material for Dynamics Hazards During Transportation
Designing a product-packaging system is a complex challenge for engineers. Building a suitable and sustainable system the packaging engineers have to take into consideration many aspects, demands and requirements. To pro...
A Review of Current Challenges in Production Planning
For manufacturing companies growing customer expectations, shortening product life cycles and increasing product variant numbers mean great challenges. Overcoming these is a major task for production planning, which is r...