MECHANICAL BEHAVIOUR OF SMALL LOAD BEARING STRUCTURES FABRICATED BY 3D PRINTING
Journal Title: Applied Engineering Letters - Year 2019, Vol 4, Issue 3
Abstract
3D printing is state‐of‐the‐art manufacturing technology. In addition to prototyping, the development of this technology allows the parts produced by this technology to be used as fully functional assemblies. There are different 3D printing technologies (Fused Deposition Modeling, FDM, Selective Laser Sintering, SLS, Stereolithography, SLA and others), and different materials can be used (polymer filaments, polymer and composite powders for sintering, photopolymers). This paper presents the process of design and fabrication of small load bearing structures by FDM and verification of its mechanical properties, by using three‐point bending test. The printing parameters and setup of the three‐point bending test were analysed from aspects of flexural strength and final bending angle that was determined experimentally and by calculation.
Authors and Affiliations
Nikola Palić, Vukašin Slavković, Živana Jovanović, Fatima Živić, Nenad Grujović
INFLUENCE OF THE PVD PROCESS PARAMETERS ON ZNO: AL THIN FILMS
In recent years a growing interest in searching new material for producing Transparent Conductive Layers (TLC) is observed. ZnO:Al thin films are this type material, interesting due to wide range of potential application...
MECHANICAL, MICROSTRUCTURE AND WEAR BEHAVIOUR OF LM25/SiC/MICA METAL MATRIX COMPOSITE FABRICATED BY SQUEEZE CASTING TECHNIQUE
Metal matrix composite (MMC) has a unique class of light weight advanced engineered materials which are developed to give high strength, improved hardness, tensile strength, good elongation and good resistance to wear an...
PROTECTION OF DATABASE IN MACHINE INDUSTRY AND DEFENSE OF CYBER ATTACK WITH ANTIVIRUS AND FIREWALL PROTECTION
The main objective of this paper is to show the technology to protect computer systems using firewall technology and through the configuration of firewall, construct defence and protection of the database of the mechanic...
EFFECT OF ALUMINA AND GRAPHENE ON MECHANICAL AND TRIBOLOGICAL BEHAVIOUR OF Al‐7075 HYBRID COMPOSITE
In this paper the combined effect of alumina and graphene reinforced with aluminum matrix by using stir casting methodology, was evaluated. Hybrid metal matrix composites gives combined results effect of different reinfo...
INVESTIGATIONS ON THE PHOSPHOROUS CAST IRON DESTINED FOR BRAKE SHOES MANUFACTURING
The choice of friction material can have a direct influence on the wear life of the brake block or wheel, which is typically much more expensive to replace. The classical cast iron brake block is gradually replaced by or...