Methodology for determining angular displacement in three-phase transformers
Journal Title: TecnoLógicas - Year 2017, Vol 20, Issue 38
Abstract
This paper presents methodology for determining angular displacement (connections or vector group (colloquial)) in three-phase transformers. The proposed methodology is useful to determine the angular displacement if connections are known or the connections if angular displacement is known. Even though connection of three-phase transformers requires knowledge of angular displacement; the technical literature does not report a rigorous methodology or procedure for their explicit step by step determination. However, there are numerous applications in the areas of engineering and research that use time group connections. This paper presents the methodology for determiningthe Yy, Yd, Dy, Dd, Zy and Zdconnections; includingthe use of time groups in some relevant engineering applications. The proposed methodology can be applied for commercial and noncommercial transformers, and also for power and distribution transformers.
Authors and Affiliations
Nicolás Muñoz-Galeano, Jesús M. López-Lezama, Fernando Villada-Duque
Keywords
Related Articles
- EP ID EP401340
- DOI 10.22430/22565337.580
- Views 109
- Downloads 0
Quality of service evaluation based on network slicing for software-defined 5G systems
This paper presents the evaluation of the quality of service parameters provided by the network slicing approach for 5G networks based on a software-defined networking environment.The open source contro...
Spectral analysis through filter banks aplied to preprocessing oriented to thresholding of pulse oximetry signal
The pulse oximetry signal (SPO2), allows the calculation of the oxygen saturation level in the blood, and it is acquired over the index finger of the patient. Under normal conditions, the variations in SPO2 have correlat...
Numerical and experimental validation with bifurcation diagrams for a controlled DC–DC converter with quasi-sliding control
This paper presents a stability analysis of a buck converter usinga Zero Average Dynamics (ZAD) controller and Fixed-Point Induction Control (FPIC) when the control parameter 푁, the reference vo...
Microstructure and adhesive-cohesive strenght of nickel, tungsten carbide and chromium oxide thermal spray coatings
Four thermal spray coatings were applied by oxy-fuel process onto ASTM A743 CA6NM (13Cr-4Ni) steel, namely: two Ni-rich alloys, a chromium oxide and a combined tungsten carbide/Ni-Cr particles coating. The microstructure...
Evaluation of Virtual TeachingLearning Environments based on usability standards
The main objective of this review article is to determine the necessary sub-characteristics or aspects for the evaluation of Virtual Teaching-Learning Environments (VTLEs) as final or...