Microwave antennas, based on dielectric resonators circular arrays
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2011, Vol 0, Issue 44
Abstract
It’s examined 2-D structures, representative by a cylindrical Dielectric Resonator (DR) system, situated on the planar metal surface around active irradiator, coupled with microwave line. Every DR becomes excited on it lowest resonance , and all structure as a whole are passive reflecting system, forming directional diagram of active radiation source. It’s demonstrated, that similar structures may effectively sharpen a directional diagram of antennas. On the basis an approximate solution of Maxwell equations has been developed antenna model. The basic antenna parameters – the radiation pattern, DR amplitudes and reflection coefficient, has been calculated. It’s investigated a possibility of working frequency band widening with improvement of radiation pattern.
Authors and Affiliations
A. Trubin
Modeling and rapid method measurement diagram RCS horn antennas
Introduction. The development of new technology and reliable operation of radio systems requires knowledge of the scattering of radio waves by radar targets. For solids of complicated form there is no sufficiently accura...
Definition of weight coefficient in two-stage automatic compensation based on LMS-algorithm and interference correlation characteristics
Introduction. Two-stage digital automatic compensators of active noise interference based on LS and RLS-algorithms provide parallel processing of signals and capability to connect/disconnect additional compensation chann...
Ion-selective field-effect transistors. Threshold voltage calculation
Ion-selective field-effect transistors (ISFET) are being developed and improved to study ion solution composition. It is necessary to determine threshold ISFET voltage on the basis of process data for design and improvem...
Radiometry notdestroying control of dielectric materials
The system is offered non-destructive radiothermal and radar methods of control of technological parameters of heat-resistant wares from sitall, sitall and quartz ceramics in the workplace. The mechanism of removal and t...
The constructional conception of the effectiveness of navigational service rising for navigation on inland water routes
Constructional conception of rising of the effectiveness of navigational service on inland water routes is described. The article demonstrates that using of this conception and informational recourses permit to raise the...