Modeling a Small Punch Testing Device
Journal Title: Engineering, Technology & Applied Science Research - Year 2014, Vol 4, Issue 2
Abstract
A small punch test of a sample in miniature is implemented in order to estimate the ultimate load of CrMoV ductile steel. The objective of this study is to model the ultimate tensile strength and ultimate load indentation according to the geometrical parameters of the SPT using experimental data. A comparison of the model obtained with the two models (European code of practice and method of Norris and Parker) allows the design and dimensioning of an indentation device that meets the practical constraints. Implemented as a Matlab program, allows the investigation of new combinations of test variables.
Authors and Affiliations
S. Habibi, A. Ziadi, A. Megueni
Keywords
Related Articles
- EP ID EP91037
- DOI -
- Views 270
- Downloads 0
Designing an Optimal Lightning Protection Scheme for Substations Using Shielding Wires
An optimal lightning protection scheme for a substation using shielding wires is investigated in this paper through computer software analysis. An economic approach is utilized by choosing a reasonable trade-off between...
Modeling and Control of a DFIG-Based Wind Turbine During a Grid Voltage Drop
Doubly-fed induction generators (DFIG) are widely used in wind energy generation systems. During a grid voltage drop, performance is degraded with rotor over current deteriorating the fault-ride through (FRT) capability...
A Hydrological Response Analysis Considering Climatic Variability: Case Study of Hunza Catchment
The hydrological response of mountainous catchments particularly dependent on melting runoff is very vulnerable to climatic variability. This study is an attempt to assess hydrological response towards climatic variabili...
PFC Control for LED Lamp Driver Using Sensorless Predictive Current Controller
Light-emitting diodes (LEDs) have recently become of utmost significance to replace conventional lighting sources. Power factor correction (PFC) control of LED lamps requires three sensors which cause more cost, increase...
A Compact Tri-Band Bandpass Filter with High Out-of-Band Rejection
This paper presents a planar tri-band bandpass filter with high out-of-band rejection over a wide band. The filter is based on two pairs of λ/4 resonators embedded inside an open loop ring resonator without any size incr...