Modern Wind Turbines Capacity Utilization in Real Conditions
Journal Title: Energy Engineering and Control Systems - Year 2017, Vol 3, Issue 2
Abstract
The development of the national wind power industry in Ukraine faces a number of problems because of the lack of sufficient information on the peculiarities of the operating modes of wind farms under real-life conditions. This applies to wind load indices in different regions, estimates of the performance of wind power plants with different types of wind turbines. One of the important characteristics of the potential capabilities of a wind power plant in the grid is the time and rate of utilization of installed capacity (installed capacity utilization factor - ICUF), which are widely used in the design of power plants. The paper presents the results of calculating the characteristics of the production potential of wind power plants with generators of different types and capacities, which are defined in terms of time and coefficient of utilization of the installed capacity. It is shown that such characteristics of the wind power station uniquely characterize the efficiency of the application of a specific wind generator in real conditions for use in design calculations.
Authors and Affiliations
Kostiantyn Pokrovskyi, Olgerd Mavrin, Andriy Muzychak, Volodymyr Oliinyk
Keywords
Related Articles
- EP ID EP258889
- DOI 10.23939/jeecs2017.02.047
- Views 55
- Downloads 0
Temperature Dependence Estimation of the Vibration and Frequency Sensor Resonator Mechanical State
The complex of technological and metrological researches concerning development of filamentous monocrystals application and fixing methods on various materials of substrate (elastic elements) is considered. The ways of u...
Gas Dynamical Capillary Flowmeters of Small and Micro Flowrates of Gases
The possibility of application of glass capillary tubes (CTs) as sensors of small and micro flowrates of gases was justified. The accuracy of a number of CTs flowrate equations was analyzed on the basis of experimental s...
Physical Modeling of Thermal Processes of the Air Solar Collector with Flow Turbulators
The analysis of existing systems of solar air heating has been carried out. The physical model of the solar air collector (SAC) with additionally installed flow turbulators, which are located in the air channel of the so...
Simulation of Dynamic Processes of Gas Flow in Collector Systems
By using CFD-simulation, plug length simulation of local resistance type plugged tee, which changes the flow direction, using equations of hydrodynamics was carried out. During simulation, velocity of medium in the threa...
Design of Optimal Filter for Analog Signal
The technique for designing the optimal value of the filter time constant for analog signal is presented in the paper. This technique is based on the objective function which takes into account the quality index of the f...