Morphology Analysis and Corrosion Performance on Aluminum Zirconium Composite

Abstract

The high strength aluminum alloy 5083 of composition 0.4Si 0.4Fe 0.1Cu 0.4Mn 4Mg 0.25 Zn 0.15Ti 0.05Cr and Al balance which has high yield strength of around 200 MPa and tensile strength of 300 MPa and good corrosion resistance for sea water and saline environments, is alloyed with zirconium (Zr), which is highly resistant to heat and corrosion, very strong, malleable and ductile, at various compositions. The alloying element zirconium metal powder is mixed at different proportions of 0.3 wt%, 0.5 wt% and 0.7 wt% with aluminum 5083 as the base metal. Corrosion resistance and morphological properties of the samples were investigated by potentiostatic polarization, scanning electron microscope (SEM) and x-ray diffraction (XRD) tests. The corrosion study has been carried out in 3.5 % NaCl solution at a sweep rate of 1mV/s. After open circuit potential has become stable, the pitting corrosion behavior has been studied after 6 hours of immersion, at a temperature of 350C and a pH value of 7. The results show that the addition of zirconium has increased the corrosion resistance of the aluminum alloy, 0.7 wt% of zirconium sample has given the best results and great resistance against corrosion, allowing them to be applicable for direct application for saline environment.

Authors and Affiliations

Belgin Paul . D. L, Neela Murali . V. K, Karthick. M

Keywords

Related Articles

The Assessment of Contact Fatigue Endurance of Rails in Real Operating Conditions

The article deals with the technique allowing the assessment of rail endurance with respect to contact fatigue durability with consideration of intensity of lateral wear of railhead. The method provides for taking into a...

Advanced Fabricated Setup for Day Long Production of Hot Water by Fresnel Lens

This work has been aimed to collect the solar energy source from Fresnel lens and utilize it to produce hot water or steam. The setup consists of a large spot Fresnel lens which concentrates the sun's rays into a one-cen...

WING STRUCTURAL ANALYSIS USING DIFFERENT FIBER REINFORCED COMPOSITES AND HYBRID COMPOSITES

Modeling the wing in ANSYS Mechanical APDL using working model parameters and applying the loads accordingly. The idealization of the wing and all its structural components to a single wing element. Obtaining the results...

Cycle Time Optimized Path Planning for Industrial Robot using Robomaster

The main aim of the paper is to demonstrate the optimal cycle time taken by a 6 axis industrial robot, by following the shortest path. Planning for path is important because, it allows knowing about the path traversal of...

PAINT PEEL OFF- A NUISANCE IN AUTOMOTIVE PROPELLER SHAFT ASSEMBLY

Manufacturing an automotive propeller shaft is really a challenging process. The propeller shaft consists of many sub components known as sub-assemblies. The sub components like Stub yoke, Flange Yoke, Sleeve Yoke, Tube,...

Download PDF file
  • EP ID EP656731
  • DOI 10.24247/ijmperdaug2019103
  • Views 88
  • Downloads 0

How To Cite

Belgin Paul . D. L, Neela Murali . V. K, Karthick. M (2019). Morphology Analysis and Corrosion Performance on Aluminum Zirconium Composite. International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ), 9(4), 1005-1014. https://europub.co.uk/articles/-A-656731