Multi-Objective Optimization in Electric Discharge Machining of Aluminium Composite
Journal Title: Tribology in Industry - Year 2014, Vol 36, Issue 4
Abstract
This paper involves the optimization of input process parameters in Electric Discharge Machining of Aluminium hybrid Metal Matrix Composite. Aluminium AlSi10Mg alloy reinforced with 9 %wt. alumina and 3 %wt. graphite particles fabricated through liquid metallurgy route was used for machining. Experiments were conducted in an Electric Discharge Machine and the influence of input process parameters such as Peak current, Pulse-on time and Flushing pressure during machining of aluminium composite was studied. The objective was to obtain a minimum surface roughness with minimum tool wear rate and maximum material removal rate. Multi-objective optimization of the input process parameters was performed by employing Artificial Neural Network and Genetic Algorithm hybrid optimization technique. The results obtained provide a pareto-optimal solution set that offers a set of non-dominated solutions that can be used in a practical situation by a decision maker.
Authors and Affiliations
N. Radhika , P. Shivaram , K. T. Vijay Karthik
Keywords
Related Articles
- EP ID EP132136
- DOI -
- Views 115
- Downloads 0
Tribological Properties of Silicone Rubber-Based Ceramizable Composites Destined for Wire Covers. Part II. Studies of Ball-on-Plate, Plate-on-Plate and Ring-on-Plate Friction Contact
Tribological properties of commercially available silicone-based ceramizable composites were studied. Friction forces of three different types of ceramizable composites were measured against three different-shape steel s...
Effects of Velocity-Slip and Viscosity Variation in Squeeze Film Lubrication of Two Circular Plates
A generalized form of Reynolds equation for two symmetrical surfaces is taken by considering velocity-slip at the bearing surfaces. This equation is applied to study the effects of velocity-slip and viscosity variation f...
Corrosion Behavior of Compocasted ZA27/SiCp Composites in Sodium Chloride Solution
The corrosion behavior of particulate ZA27/SiCp composites in an aerated sodium chloride solution was studied. The composites were synthesized via compocasting with addition of 1, 3 and 5 wt.% SiC particles in the matrix...
Wear Characteristics of Hybrid Composites Based on Za27 Alloy Reinforced With Silicon Carbide and Graphite Particles
The paper presents the wear characteristics of a hybrid composite based on zinc-aluminium ZA27 alloy, reinforced with silicon-carbide and graphite particles. The tested sample contains 5 vol.% of SiC and 3 vol.% Gr parti...
Static Performance of Surface Textured Magnetorheological Fluid Journal Bearings
Previous studies of journal bearings with artificial texturing on the bearing surface show potential benefits in certain cases. These benefits are usually focused on a specific operating area of the bearing, whereas unde...