Cascaded Multilevel Inverter with PWM Control Method
Journal Title: INTERNATIONAL JOURNAL OF ENGINEERING TRENDS AND TECHNOLOGY - Year 2013, Vol 4, Issue 5
Abstract
A hybrid cascaded multilevel inverter with PWM method is presented in this paper. It consists of a standard 3-leg inverter (one leg for each phase) and Hbridge in series with each inverter leg. It can use only a single DC power source to supply a standard 3-leg inverter along with three full H-bridges supplied by capacitors. Multilevel carrier- based PWM method is used to produce a five-level phase voltage. The inverter can be used in hybrid electric vehicles (HEV) and electric vehicles (EV). A simulation model based on PSIM and MATLAB/SIMULINK is developed. An experimental 5 kW prototype inverter is built and tested. The results experimentally validate the proposed PWM hybrid cascaded multilevel inverter.
Authors and Affiliations
M. Kiran Kumar #1 , M. Saikiran *2 , Ch. Venkateswarlu
Keywords
Related Articles
- EP ID EP114899
- DOI -
- Views 99
- Downloads 0
Spatio-Temporal Video Denoising by Block-Based Motion detection
This paper proposes a new video denoising technique where spatially adaptive noise filtering in wavelet (transform) domain is combined with temporal filtering in signal domain. AWGN is being considered which beha...
A Nonlinear Controller for Photovoltaic Water Pumping System
The aim of this work is to suppy an energy for photovoltaic cell and that energy will go to the inverter and then went to induction motor to be operating certain speed then water pumb process achieved. Main target...
Soft Pre Generalized - Closed Sets in a Soft Topological Space
This paper introduces soft pre-generalized closed set in soft topological spaces. The notations of soft pre interior and soft pre closure are generalized using these sets. In a soft topological space, a soft set F_A is s...
Study Of Single and Multi Wavelength(WDM) EDFA Gain Control Methods
The purpose of this paper is to provide an introduction to EDFA and discussing various gain flattening techniques.EDFA is widely used amplifier due to its transient suppression, wide band variable gain operation....
Comparison of Bending Stresses for Different Face Width of Helical Gear Obtained Using Matlab Simulink with AGMA and ANSYS
Helical gears are widely used in industry where the power transmission is required at heavy loads with smoother and noiseless operation. The study in this paper shows that the complex design problem of helical gear...