Comparison of Bending Stresses for Different Face Width of Helical Gear Obtained Using Matlab Simulink with AGMA and ANSYS
Journal Title: INTERNATIONAL JOURNAL OF ENGINEERING TRENDS AND TECHNOLOGY - Year 2013, Vol 4, Issue 7
Abstract
Helical gears are widely used in industry where the power transmission is required at heavy loads with smoother and noiseless operation. The study in this paper shows that the complex design problem of helical gear requires superior software skills for modelling and analysis. The above problem can be resolved using MATLAB Simulink environment which provides equivalent results to the AGMA and also with ANSYS.In this paper we modelled a helical gear on Pro engineer wildfire 5.0 and stress analysis part is done on ANSYS 12.0. A Simulink model is generated by using curve fitting. The results are compared with both AGMA and FEM procedures.
Authors and Affiliations
Pushpendra Kumar Mishra1 , Dr. M. S. Murthy
Keywords
Related Articles
- EP ID EP120412
- DOI -
- Views 73
- Downloads 0
A Miniscule Endeavour for Accomplishing Hypo Sludge Fly Ash Brick in Indian Context
Paper waste can be recycled only a limited number of times before they become too short or weak to make high quality paper. Thus the broken, low- quality paper fibers are separated out to become waste sludge known as hyp...
Laser Machining of Polymer Matrix Composites: Scope, Limitation and Application
This paper presents an overview of laser beam machining and researches carried out so far in the area of laser cutting of polymer matrix composites. Composite materials are highly promising materials for applicatio...
Speed Control of Induction Motor using Cycloconverter
This method is used to control the speed of the induction motor .The speed control by this method is simple and can be made economical by using different methods to control the operation of cycloconverter which in...
Study Of Single and Multi Wavelength(WDM) EDFA Gain Control Methods
The purpose of this paper is to provide an introduction to EDFA and discussing various gain flattening techniques.EDFA is widely used amplifier due to its transient suppression, wide band variable gain operation....
Design of Low Density Parity Check Decoder for WiMAX and FPGA Realization
Error detection and correction is one of the most important blocks of a communication system. In order to achieve reliable communication over noisy channels with low power consumption, are used for error correction...