Design and Characterization of Microstrip Diplexer
Journal Title: INTERNATIONAL JOURNAL OF ENGINEERING TRENDS AND TECHNOLOGY - Year 2012, Vol 3, Issue 2
Abstract
The paper focuses on a systematic design process and realization of a diplexer in printed circuit configuration.The diplexer is practically a 3 port structure having one input and two output ports.The structure consist of two filters having different passband with a common input port ( diplexer input) and output ports of two filters acts as diplexer output.In this work the diplexer is required to meet some stringent specifications regarding size, insertion loss and return loss at input and output ports.
Authors and Affiliations
Manidipa Nath,
Keywords
Related Articles
- EP ID EP93172
- DOI -
- Views 121
- Downloads 0
Investigation of Corrossion Effects of Jatropha Biodiesel on the Injector of an Engine Fuel System
This paper presents an investigation into the corrosive behaviour of biodiesel on the injector of the fuel system of a diesel engine. The experimental study was based on the methods of weight loss and scanning electron m...
Design, Modelling and Analysis of a Single Raw Four Point Angular Contact Split Ball Bearing to Increase its Life
In this paper design of four points angular contact ball bearing is done which is used in Propeller shaft of an air craft.This type of ball bearing can support radial load and axial load in both directions due to t...
Design And Motion Planning of Two Module Indoor Pipeline Robot
This paper deals with a design and motion planning algorithm of a pipeline robot that can be used for inspection of 80–100 mm pipelines in an indoor pipeline environment. The robot system uses a four dc motor to drive an...
Comparative Study of PI Controlled and Fuzzy Controlled Buck Converter
The main objective of this paper is to compare the performance between fuzzy controller and proportional integralcontroller in improving the performance of the DC-DC Buck Converter. The evaluation of the output has...
ARM7 BASED SMART CAR SECURITY SYSTEM.
main aim of this project is to offer an advance security system in CAR, which consists of a face detection subsystem, a GPS module, a GSM module and a control platform. The face detection subsystem can detect fac...