Experimental Comparison Study for Savonius Wind Turbine of Two & Three Blades At Low Wind Speed
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2013, Vol 3, Issue 5
Abstract
In this project, experimental comparison and investigations were carried out to study the performance and to make a comparison between two and three blades Savonius wind turbine. For this purpose, two models of two and three blades were designed and fabricated from Aluminum sheet, each of them has an aspect ratio of ( As = H/D =1), the dimension is ( H = 200 mm height and diameter D = 200 mm) and the blades were made of semi – cylindrical half of diameter (d = 100 mm). The two models were assembled to have (overlap e = 0 and a separation gap e'= 0).
Authors and Affiliations
Mohammed Hadi Ali
Keywords
Related Articles
- EP ID EP110016
- DOI -
- Views 120
- Downloads 0
A Novel High Performance H-Bridge Converter Topology for 8/6 pole SRM Drive
Despite of the fact that obviously less complex, the SRM drives are these days more expensive than their formal AC drive systems. This is, all things considered brought about by the absence of an optimal power...
A High Performance PWM Voltage Source Inverter Used for VAR Compensation and Utility Grid Stability Improvement
A high performance advanced static VAR compensator (ASVC) which uses a Pulse Width Modulation (PWM) voltage source inverter is presented and analyzed in this paper. A fast control approach of the ASVC system has...
High Speed Trains
Abstract: When English inventor Richard Trevithick introduced the steam locomotive on 21 February 1804 in Wales, it achieved a speed of 8 km/h (5 mph). In 1815, Englishman George Stephenson built the world's first...
An Overview of Distributed Generation
The Power Generated in Karnataka(INDIA) is 7445.91MW and Demand is 8500MWwhich causes the problem of Load shedding, many states face this problem and are forced to buy the power from other states which leads to t...
Effect of operating Parameters in Grinding
The grinding process depends on operating parameters like feed rate, depth of cut and speed. These parameters are co-related with each other and are equally important to optimize the grinding process in terms of...