Experimental Investigation & Analysis of Process Parameter in Machining Of Aluminum Based Metal Matrix Compoite
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 3, Issue 1
Abstract
Mach inability of aluminium alloy (A-356) reinforced with coconut shell ash 10%wt) and fly ash(10%wt) particles fabricated with stir casting process was investigated. The mach inability and mechanical properties of the metal matrix composites was studied by performing machining in lathe, hardness test and tensile test. In this paper mach inability is evaluated by studying various data parameter of aluminium alloy (A-356) and A-356+ 10% Fly ash and A-356+ 10% coconut shell ash such as cutting force, surface roughness, chip thickness during turning at different cutting speed and constant depth of cut and feed rate. In this paper also study mechanical properties means hardness and tensile strength of the aluminium alloy (A-356) and A-356+ 10% Fly ash and A-356+ 10% coconut shell ash were subjected to testing the hardness test and tensile test.
Authors and Affiliations
Prakash Kumar Dalai
Keywords
Related Articles
- EP ID EP163995
- DOI -
- Views 68
- Downloads 0
FATIGUE LIFE PREDICTION OF COMPOSITE SEMI - ELLIPTICA L LEAF SPRING FOR HEAVY VEHICLE
A leaf spring is a simple form of spring, commonly used for the suspension in wheeled vehicles. Leaf Springs are long and narrow plates attached to the frame of a trailer that rest above or below the trailer's axle. Th...
Fuzzy Controller Based UPQC for Power Quality Improvement
The paper proposes a unified power quality controller (UPQC) using a fuzzy logic controller (FLC). The results obtained through the FLC are good in terms of dynamic response because of the fact that the FLC is bas...
Analysis of Creep Life of Steam Turbine Blade by Using Different Material
Turbine Blades are the main component of any steam power plant and have to withstand in very high temperature. The main aim of this paper is to calculate the creep life of 210MW Reheat Reaction Turbine Blade by c...
An invesgation of En8 Material on Abrasive Water jet Machine
Abrasive water jet machine (AWJM) is a nontraditional machining process. Abrasive water jet machining is a process of removal of material by impact erosion of high pressure (1500-4000 bar), high velocity of water...
Urbanization & Urban Land-Use Mapping Using Remote Sensing & GIS
A study on “Urbanization & Urban Land-use mapping” was carried out using IRS Satellite data of LISS III and LISS IV covering Gandhinagar city. The GIS data like the Transport Network, Urban Habitation, Bridge...