Fatigue of weld ends under combined in- and out-of-phase multiaxial loading
Journal Title: Frattura ed Integrità Strutturale - Year 2016, Vol 10, Issue 38
Abstract
Weld start and end points are fatigue failure sensitive locations. Their fatigue behaviour especially in thin sheet structures under multiaxial load conditions is not sufficiently explored so far. Therefore, a research project was initiated to increase the knowledge concerning this topic, which is of special interest in the automotive industry. In the present study, fatigue tests on welded joints were conducted. In the numerical part of the study, notch stresses were calculated with an idealised weld end model. A numerical method which combines the geometrical and statistical size effect to an integrated approach was used, in order to consider the size effects
Authors and Affiliations
E. Shams , M. Vormwald
Keywords
Related Articles
- EP ID EP90975
- DOI 10.3221/IGF-ESIS.38.15
- Views 98
- Downloads 0
Pearlitic ductile cast iron: damaging micromechanisms at crack tip
Ductile cast irons (DCIs) are characterized by a wide range of mechanical properties, mainly depending on microstructural factors, as matrix microstructure (characterized by phases volume fraction, grains size and...
Fatigue of weld ends under combined in- and out-of-phase multiaxial loading
Weld start and end points are fatigue failure sensitive locations. Their fatigue behaviour especially in thin sheet structures under multiaxial load conditions is not sufficiently explored so far. Therefore, a res...
Design of a novel magnetorheological damper with internal pressure control
In this work we designed and manufactured a novel magnetorheological (MR) fluid damper with internal pressure control. Previous authors’ works showed that the yield stress τB of MR fluids depends both on the magne...
Microstructural study of multiaxial low cycle fatigue
This paper discusses the relationship between the stress response and the microstructure under tension-torsion multiaxial proportional and nonproportional loadings. Firstly, this paper discusses the material depe...
New experimental techniques for fracture testing of highly deformable materials
A new experimental method for measuring strain fields in highly deformable materials has been developed. This technique is based on an in-house developed Digital Image Correlation (DIC) system capable of accu...