Modeling & Simulation of PMSM Drives with Fuzzy Logic Controller
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2013, Vol 3, Issue 4
Abstract
The Permanent-magnet-synchronous-machine (PMSM) drives have been increasingly applied in a variety of industrial applications which require fast dynamic response and accurate control over wide speed ranges. In this thesis the control of a Permanent Magnet Synchronous Motor (PMSM) is studied. Usually, a proportional-integral (PI) controller is used as a speed controller for a Permanent Magnet Synchronous Motor (PMSM). However, a PI controller is sensitive to speed changes, load disturbances and parameters variation without continuous tuning of its gains. The conventional approach is to tune the proportional and integral gains manually by observing the response of the system. The tuning of the PI parameters must be made on-line and automatic in order to avoid tedious tasks in manual control.
Authors and Affiliations
Praveen Kumar
Keywords
Related Articles
- EP ID EP141322
- DOI -
- Views 123
- Downloads 0
A Novel Data Leakage Detection
Abstract: This paper contains concept of data leakage, its causes of leakage and different techniques to detect the data leakage. The value of the data is incredible, so it should not be leaked or altered. In the f...
Application of Intuitionistic Fuzzy Soft Matrices in the Analysis of the Expectations of Old Age People
In our real life, we are facing the situations involving uncertainty, imprecision and vagueness. To deal with these situations the concept of Soft set was developed. To enhance the flexibility of its applicatio...
Developing Infrared Controlled Automated Door System
As a result of enhanced civilization and modernization, the human nature demands more comfort to his life. Automated doors have acquired and have become part of one’s life from his office to shopping complex. Aut...
Testing of Already Existing and Developing New Compaction Equations during Cold Die Compaction of Iron-1.05% Graphite Powder Blends
Powder Metallurgy (P/M) processing of materials to produce conventional P/M parts involve the compaction of the pre-determined mass of individual elemental, mixed elemental metal powders or alloy powders and or composite...
Tannin gel derived from Leaves of Ricinus Communis as an adsorbent for the Removal of Cu (II) and Ni (II) ions from aqueous solution
The biosorption of Cu (II) and Ni (II) ions from aqueous solutions by Tannin gel derived from Leaves of Ricinus Communis was investigated as a function of pHZPC, Initial pH, adsorbent dose, contact time and m...