MULTI-OBJECTIVE OPTIMIZATION OF MRR, Ra AND Rz USING TOPSIS
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 5, Issue 9
Abstract
The multi-criteria decision making methods are very significant in solving the engineering problems which involves in critical decision making situations. In the present work the effect of cutting parameters on the responses was studied using most familiar multi-criteria methods like WSM, WPM and TOPSIS. The experiments were done on CNC lathe using Tungsten carbide tool under dry environment. Cutting parameters of speed, feed and depth of cut were taken as input parameters and Material Removal Rate (MRR), Arithmetic average Roughness (Ra), Average peak to valley height Roughness (Rz) were considered as the responses. The experiments were conducted as per the taguchi’s standard L9 Orthogonal Array. From the results of WSM, WPM and TOPSIS it is found that the ninth alternative i.e. speed at 225 m/min, feed at 0.15 mm/rev and depth of cut at 0.4 mm, is the best among all the experiments.
Authors and Affiliations
Ch. Maheswara Rao*,
Keywords
Related Articles
- EP ID EP101782
- DOI 10.5281/zenodo.154209
- Views 101
- Downloads 0
UNDER DISTORTED GRID VOLTAGE DIRECT POWER CONTROL OF DOUBLY FED INDUCTION GENERATOR
This paper presents a direct power control strategy for a doubly fed induction generator based wind power By analyzing the six times grid frequency power pulsation produced by the fifth and seventh grid voltag...
EFFECT OF TOTAL QUALITY MANAGEMENT ON CUSTOMER SATISFACTION
Purpose: The purpose of this research is to provide an intermediate step to understanding the complex relationship between total quality management and customer satisfaction. This study presents research which examines...
QUALITY OF SERVICE AND TRAFFIC ENGINEERING IN MPLS NETWORK BY FUZZY LOGIC COMPUTING : A BRIEF STUDY
This research paper suggests a load balancing algorithm using fuzzy logic methodology so that maximum Quality of Service can be attained. Avoidance of jamming of packets is one of the key performance objectives of...
LI-FI (Light Fidelity)-The Future Technology in Wireless Communication
Li-Fi is a new wireless technology to provide the connectivity with in localized network environment .As in practical term whether you’re using wireless internet in a coffee shop ,stealing it from the guy next doo...
LOW COST FLYING BOT USED FOR AERIAL PHOTOGRAPHY AND FACE DETECTION
This article deals with designing and fabrication of a robot which is capable of flying and performs several tasks with ease & speed. A lot of manpower & energy is used for aerial photography from a far distance....