OPTIMIZATION OF CUTTING PARAMETERS TO IMPROVE SURFACE ROUGHNESS OF AL 1070 IN TURNING OPERATION USING TAGUCHI METHOD
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 5, Issue 7
Abstract
Recently the concept of hard turning has gained much attention in the metal cutting industry. In hard turning, multiple operations can be performed in single step, thereby it replaces the traditional process cycle. But it involves very large quantities of cutting fluid. Procurement, storage and disposal of cutting fluid involve expenses and environmental problem. Pure dry turning is a solution to this problem as it does not require any cutting fluid at all. But pure dry turning requires ultra hard cutting tools and extremely rigid machine tools, and also it is midcult to implement in the existing shop floor as the machine tool may not be rigid enough to support hard turning. In this context, turning with minimal fluid application is a viable alternative wherein, extremely small quantities of cutting fluid are introduced at critical contact zones as high velocity pulsing slugs, so that for all practical purposes it resembles pure dry turning and at the same time free from all the problems related to large scale use of cutting fluid as in conventional wet turning. In this study, fluid application parameters that characterize the minimal fluid application scheme were optimized and its effect on cutting performance and tool vibration was studied. From the results, it was observed that minimal fluid application in the optimized mode brought forth low vibration levels and better cutting performance.
Authors and Affiliations
Mohd Abbas
Keywords
Related Articles
- EP ID EP149262
- DOI 10.5281/zenodo.58657
- Views 63
- Downloads 0
EMI/EMC Analysis and Noise Reduction in High Frequency Devices
Electromagnetic interference (EMI) or radio frequency interference (RFI) is a type of electric or electronic emission that can degrade the performance of electronic circuit.The effects of electromagnetic interfere...
SIMPLEST PHASE NOISE MITIGATION TECHNIQUE IN OFDM SYSTEM
In Orthogonal Frequency Division Multiplexing Communication systems, the local oscillator used for the upconversion and down-conversion at the transmitter and receiver respectively introduces phase noise which cau...
THE STRUCTURAL MODEL FOR EVALUATING THE ROLE OF LOCAL GOVERNMENT IN CULINARY TOURISM
This paper aimed to study the effects of local government role in developing culinary tourism sustainability. By choosing Kedonganan Beach, one of two famous culinary destination at Bali – Indonesia, two types of...
ULTRA HIGH SPEED PROTECTION AND SPEED CONTROL SYSTEM OF DC MOTOR USING LABVIEW
The software developed is very useful and by interfacing it using DAQ card, very low cost DC motor protection can be achieved. Further it shows monitoring of electrical measurements.
Human Identification Based On Scleral Vasculature
The blood vessel patterns of sclera show rich and unique details. To date, sclera is relatively less studied and little is known regarding its usefulness and performance. Here, sclera recognition for human identif...