Total Harmonic Distortion Analysis and Comparison of Diode Clamped Multilevel Z-Source Inverter
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2013, Vol 3, Issue 2
Abstract
Abstract: A desired AC voltage is achieved from several levels of DC voltages is done by multilevel inverters. These inverters are applied to high voltage and high power applications due to better harmonic spectrum and faithful output. In recent years a single X-shaped LC network is important development in multilevel inverters. The power quality improvement is obtained by reducing the harmonics present at the output voltage of the inverter. This paper presents the comparative THD analysis of several multicarrier PWM control techniques which is effectively used for harmonic mitigation in the proposed diode clamped multilevel Z-source inverter and this work is compared with conventional three level inverter by using MATLAB/SIMULINK
Authors and Affiliations
P. Vanaja
Keywords
Related Articles
- EP ID EP146227
- DOI -
- Views 97
- Downloads 0
Seismic Pounding Effect in Framed Structures
Pounding between adjacent structures is commonly observed phenomenon during major earthquakes which may cause both architectural and structural damages. To satisfy the functional requirements, the adjacent buildings are...
Comparative Analysis of Transformer and Transformer Less-Based Variable DC Power Supply
Abstract: Electronics circuitry needs DC power source of a specific value to work effectively. This paper considers the design and evaluation of transformer-based and transformer less-based variable regulated...
Detection of Duplicate Address in Mobile Adhoc Networks for On Demand Routing Protocols
MANET is a wireless network in which all nomadic nodes can communicate with each other without relying on a fixed infrastructure. By using the intermediate nodes we will achieve the forwarding and routing of the packet....
Finite Element Analysis of Convective Micro Polar Fluid Flow through a Porous Medium in Cylindrical Annulus
We analyze a finite element solution for the mixed convection micro polar flow through a porous medium in a cylindrical annulus. The governing partial differential equations are solved numerically by using finite element...
Noval Method for Fabrication of 3-D Spacer Fabric Composite and Investigation of Mechanical Property
The paper deals with the fabrication and flexural property studies of 3D Spacer fabrics with three different stiffener height, i.e., 5mm, 10mm and 15mm. The specimens were fabricated over two bidirectional woven fabric s...