New Generation 'Block-Modular' Condenser for K-1000-60/1500-2 Turbine Units in Zaporozhskaya NPP
Journal Title: Проблеми машинобудування - Year 2018, Vol 21, Issue 1
Abstract
The condensing devices of steam turbine plants considerably determine the reliable and economical operation of NPP power units. In some cases, breakdowns in their operation result in a forced decrease in the electric capacity of the power unit and a decline in the reliability, as well as in a significant underproduction of electric power. The main reason determining the necessity to modernize the condensers is the damage to the metal in different sections of the cooling tubes, caused by erosion-corrosion under the influence of the turbulent flow of the cooling water saturated with oxygen, as well as presence of solid particles and other contaminants, which results in the breakage of the water density of the tube systems, leakage of copper into the cycle of the turbine unit and, in the long run, in the loss of the turbine electric power, the reduction in resource and deterioration of the operational reliability of the auxiliary equipment and steam generators, which, finally, sharply worsens the performance of the NPP. A system of separate modules of complete factory readiness with assembled cooling tubes has been created, which made it possible to design a new generation ‘block-modular’ condenser, which provides high technical and economic indicators in a wide range of operating modes with the subsequent increase in turbine unit electrical power across the generator terminals through deepening the estimated steam pressure. Cooling tubes and external plates made of corrosion resistant materials are used in the condenser design, which increases reliability, efficiency, safety and prolongs the unit’s service life. The condenser design allows for the withdrawal of the uncondensed vapor-air mixture from the tube bundle and the complete condensation of the vapor coming from the turbine LPCs.
Authors and Affiliations
A. N. Uss, S. T. Patsiuk, A. V. Panchenko, D. Kh. Kharlampidi
Keywords
Related Articles
- EP ID EP622054
- DOI 10.15407/pmach2018.01.004
- Views 86
- Downloads 0
Study of the Stressed State Near the Crack That Initiates at the Inclusion Under Longitudinal Shift Wave Influence
Modern elements of building structures and machine parts often contain structural elements or technological defects that can be considered as thin inclusions of high rigidity. Reinforcing elements of composite materials...
Modeling Heat and Mass Exchange Processes in Metal-hydride Installations
Hydrogen as an environmentally friendly energy carrier is increasingly used in various sectors of the economy of industrialized countries, primarily to improve the environmental situation. Regardless of the field of appl...
Stressed State in a Finite Cylinder with a Circular Crack at Non-stationary Torsion
This paper considers a solution to an axially symmetric dynamic problem of determining the stress-state in the vicinity of a circular crack in a finite cylinder. The cylinder lower base is rigidly fixed, and the upper on...
Calculation of Indicators of Reliability of Technical Systems by the Typical Structural Scheme Method
A method for calculating the indicators of structural reliability of systems with a large number of elements is presented. The method is based on the use of typical structural schemes, reflecting the concept of connectio...
New Generation 'Block-Modular' Condenser for K-1000-60 / 1500-2 Turbine Units in Zaporozhskaya NPP
<p class="a"><span lang="EN-US">The condensing devices of steam turbine plants considerably determine the reliable and economical operation of NPP power units. In some cases, breakdowns in their operation result in a for...