NEW WAYS OF RENEWABLE SOURCES UTILIZATION FOR ELECTRICITY PRODUCTION
Journal Title: Structure and Environment - Year 2015, Vol 0, Issue 1
Abstract
Nowadays, different solutions for increasing energy production are investigated in the world. One of the ways is utilization of renewable energy sources in cogeneration devices – combined production of electricity and heat in one device, with a high overall efficiency. The article deals with principle of hot-air engine, its basic division and use in combined production of heat and electricity from biomass. The basic principle of engine is conversion of heat into mechanical energy, which is subsequently used for production of electricity. In the contribution is presented Stirling engine, which is driven by thermal energy from a concentrating solar collector and from biomass boiler.
Authors and Affiliations
PETER DURČANSKÝ, RADOVAN NOSEK, JOZEF JANDACKA
Keywords
Related Articles
- EP ID EP195300
- DOI -
- Views 108
- Downloads 0
RESEARCH PROBLEMS THAT OCCUR DURING THE ANALYSIS OF THE WORK OF FRP-STRENGTHENED TIMBER BEAMS UNDER SUSTAINED LOADS
A special focus was given to the variation in deformability characteristics of these materials and to the resulting processes that occur in the work of the strengthened beams. Aims and objectives of these studies were al...
THERMAL COMFORT IN INTELLIGENT BUILDINGS
The paper presents the issue of thermal comfort conditions with regard to intelligent buildings. First the principles of thermal comfort are discussed, namely the parameters affecting the human perception of the best ind...
IMPACT OF SUPPORT CLOSED SECTION RIBS ON THE CRITICAL MOMENT FOR LATERAL TORSIONAL BUCKLING OF STEEL BEAMS
The study presents the results of theoretical investigations into the effect produced by support closed section ribs on the critical moment for lateral torsional buckling (Mcr) of bisymmetric I-beams. Elastic restraint a...
THE COMPARATIVE ANALYSIS OF COMPUTATIONAL METHODS FE AND FD ON THE EXAMPLE OF THE MEMBRANE SURFACE STRUCTURE
The paper contains comparison of FEM and FDM applied in membranes. Innovative element of this calculation method includes replacing a membrane with a framed structure [1]. Sample membranes were tested by two methods, aft...
EFFECT OF THE ADDITION OF ASH FROM THE INCINERATION OF SEWAGE SLUDGE ON THE PROPERTIES OF CEMENT SLURRIES
The increase of quantity of ash from the combustion of sewage sludge will need to look for new methods of disposal. One method is to use sewage sludge ash as a partial substitute for cement. The oxide composition of the...