Obtaining solutions of silver nanoparti-cles under plasma discharge
Journal Title: Праці Одеського політехнічного університету - Year 2017, Vol 2, Issue 52
Abstract
The paper considers obtaining water solutions of silver nanoparticles with contact non-equilibrium low tem-perature plasma discharge. The aim of the work is to study the influence current of a discharge non-equilibrium low-temperature plasma on the composition of silver nanoparticles solutions. The investigations were carried out in a gas-liquid batch reactor the volume of which 100 ml. The reactor pressure was 80±4 kPa. The current was maintained at 120±6 mA. The time of treatment was from 10 seconds till 14 minutes. The solutions were prepared by dissolving the argentums nitrate in distilled water with a predetermined ratio. Oxidation-reduction potential was measurement 30 seconds after stopping the treatment of solutions of CNP using an ionometr I–160MI. Optical spectra of sols were recorded on the spectrophotometer UV-5800PC in the wavelength range 190…700 nm. Micrographs of nanoparticles were obtained with a scanning electron microscope REM-106I with magnification of 100…2000 times. Additional particle size analysis was performed by dynamic light scattering on a VASCO instrument (laser wavelength 658 nm). It is found, the сurrent strength in the circuit is influence to the yield of oxidized compounds and the desired product. The regularities of the change in the oxidation-reduction potential of aqueous solutions of argentum nitrate are studied depending on the concentration of AgNO3, the time of action plasma discharge and amperage. Morphological and dimensional characteristics of plasmochemical obtaining silver nanoparticles were researched. It is found the dispersion phase of nano-particles witch produced in results action of plasma discharge has size up to 50 nm and spherical form. If the amperage is growing it will produce the bigger particles.
Authors and Affiliations
M. I. Skiba, A. A. Pivovarov, A. K. Makarova, V. I. Vorobyova, I. А. Vasylenko
Keywords
Related Articles
- EP ID EP319749
- DOI 10.15276/opu.2.52.2017.14
- Views 136
- Downloads 0
Heat transfer optimization of heat exchange surfaces of boiler equipment with decrease in consumption of combustion products.
The possibility of intensifying of heat transfer process with decrease of consumption of combustion products for a given heat release is considered. Such situation can occur when alternative (uncertified) combustible gas...
Еnhancement of reliability and efficiency of cooling towers of nuclear power plants
Present paper contains results of Rivne nuclear power plant cooling towers testing to define their cooling efficiency change during continuous service by means of comparing the actual temperature of cooled water with the...
Estimation of residual strength of pipeline's elbow with volumetric corrosion defect, which is developing
Pipelines are used as one of the most practical and low cost methods for transmission of different liquid petroleum products and gases. Damage on the pipeline is capable to appear during operation due to the accumulation...
The analysis of the principles and methods evaluation of environmental safety levels in regional context
Comparison of regions of Ukraine according to relevant indicators and levels of environmental safety is the basis for developing a national strategy and organizing effective safety measures. The aim to determine prioriti...
Investigation of the influence of various factors on the power of heat exchange by radiation
The issue of lack of knowledge of radiation heat transfer process has been repeatedly raised in various studies. Despite the fact that works on study of heat transfer by radiation covers a wide range of different industr...