Operational Study of Circulating Fluidized Bed Steam Generator
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2017, Vol 7, Issue 6
Abstract
The paper aims at studying the operation of a lignite fired Circulating Fluidized bed Combustion steam generatorof 250 MW capacity located at NeyveliinTamilnadu in South India. Circulating fluidized bed combustion(CFBC) is a techno-economical alternative to conventional pulverized coal fired combustion. It is a clean coal technology and is environment friendly. From the proximate analysis,the lignite consisted of moisture (50%), sulphur (0.70%), ash (8.50%). From the ultimate analysis, the elemental composition were carbon (27.50%), hydrogen (2.20%), sulphur (0.70%) and oxygen (10.40%), nitrogen (0.20%) were found. The operational study was doneand the particle size was one of the main factor for the efficiency. Finer particles consume auxiliary power while coarser particles due to their inertia are difficult to entrain.
Authors and Affiliations
S. Bharath Subramaniam
Keywords
Related Articles
- EP ID EP256306
- DOI -
- Views 85
- Downloads 0
Comparative Modeling on Surface Roughness for Roller Burnishing Process using Fuzzy Logic
Roller burnishing is one of the surface finishing processes without removing of a material, where a roller rolls over the machined surface under high pressure and flattens, the roughness peaks into valley. It will improv...
Investigation on Performance and Emission Behaviour of a Single CylinderDiesel Engine Fueled with Mixture of Coconut Oil and Pongamiaoil Biodiesel Blends Along with Diesel
The major area of research in internal combustion engines is alternative fuels due to the financial crisis in middle east countries, depletion in crude oil resources, hike in fuel prices, and environmental degradation du...
Experimental Investigation on Mechanical Properties of AISI 316l SS Weldment by Using GTAW Process
Welding is considered as one of the most important methods of metal joining process among other joing process. In this study, GTAW and Pulsed GTAW process is are used to weld AISI 316L type of Austenitic steel(3)along w...
FINITE ELEMENT METHOD ANALYSIS OF THICKNESS OF PLATES
The advance in the improvement of using structural components for the aerospace structure is essential and their importance in the fields of engineering especially in the construction of bridges, floor panels and in the...
Application of Producer Gas from South Sumatera, Indonesia, Low Rank Coal Gasification on Spark Ignition Engine or Gasoline Engine
The substitution of oil fuel to coal continued to increase by the government of Indonesia that has been implemented on energy mix program. In this study, the low rank coal of South Sumatera, Indonesia was converted to pr...