Optimization of Gas Dynamical Subsystem of Transducers for Measurement of Gas Flow Temperature
Journal Title: Energy Engineering and Control Systems - Year 2016, Vol 2, Issue 2
Abstract
The main types of errors which occur while measuring the temperature of gas flows, including flows of fuels, are determined by the conditions of thermal balance at the interaction of the sensor of the temperature transducer (TT) with the gas flow via convection, radiation and conduction. The limited TT capacity to track flow temperature variation should also be taken into consideration. For high gas flow speeds (over 50 m/s), another type of error (the so-called speed error) arises from the transformation of part of kinetic energy of the flow into thermal energy. A comprehensive analytical study of the combined influence of all the major factors on the total error of gas flow temperature measurement with a particular TT is actually impracticable, since some relationships describing the character of influence of this or that factor can be obtained only by experiment. Therefore, in practice, each error type is analysed separately, assuming that no other types of error occur, and the total error of measurement is regarded as superposition of separate error types. For convenience of analysis, TT is represented as a combination of separate units, each with its own components of the error. TT for gas flow temperature measurements appears as three units, such as gas dynamic, thermal and electrical, connected in series. The gas dynamic subsystem transforms the thermodynamic temperature T(τ) of the gas flow at the TT input into the deceleration temperature ТПТ(τ) at the temperature sensor input and is characterized by the speed error. The defining characteristic of the gas dynamic subsystem is the TT recovery factor, which is why the paper discusses the methods and means of ensuring the constancy of the recovery factor.
Authors and Affiliations
Vasyl Fedynets, Ihor Vasylkivskyi, Yaroslav Yusyk
Keywords
Related Articles
- EP ID EP256963
- DOI 10.23939/jeecs2016.02.043
- Views 79
- Downloads 0
Methods for Defining the Binary Coal Mixture Composition in the Pulverized Coal-Fired Boiler
The paper deals with the methods for defining the composition of the coal mixture burnt in boilers at combined heat and power plants. Indirect methods for defining the proportions of the two grades of coal in the mixture...
Analytical Studies of Coolant Temperature in Solar Panel
An analysis of existing solar heating systems has been carried out. The dependence of the annual flow of solar radiation on the solar panel on the azimuthal angle γ and the angle of inclination of the surface, which can...
Alternative Energy Source for Heating System of Woodworking Enterprise
At woodworking enterprises, there is a large amount of wood waste the energy potential of which can be used as an alternative source of energy for the generation of heat energy at boiler houses. Gasification is one of th...
Measurement of Roughness of Internal Surface of Measuring Pipeline in Real Time for Standard Orifice Plates
Methods for measuring the roughness of the internal surface of a measuring pipeline for projected rectilinear sections of a measuring pipeline and for rectilinear sections that are in operation have been determined. The...
Investigation of Mill Balls Metal Deterioration in Mills KBM 370/850 (Sh-50А) when Fuel not Envisaged in the Mill Design is Used at Thermal Power Plants
Method for determining mill balls metal deterioration rate in a ball mill KBM 370/850 (Sh-50А) of dust-system of coal-dust boilers TPP-210А and TPP-312 300МW of thermal power plants is described in the paper. The researc...