Optimization of Welding Modes for High-Strength Low-Alloy Domex 700 Steel
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2017, Vol 3, Issue 2
Abstract
The microstructure and hardness of the weld joints of DOMEX 700 steel were investigated. As a result, the optimization of the parameters of robotic arc welding in the environment of protective gases was carried out taking into account the size of the energy per unit length. The optimum modes of welding were determined. The size of the deterioration area, where there is a decrease in hardness in comparison with the main metal, for a thickness of 6 mm is 2.36 mm, and for a thickness of 3 mm is 1.51 mm. The parameters of the robotic welding process in the arc mode in the environment of protective gases for the investigated thicknesses of the DOMEX 700 steel were recommended. As a result, the energy-saving conditions for welding performing were achieved ensuring the required technological strength.
Authors and Affiliations
Andrii Dzyubyk, Volodymyr Palash, Ivan Khomych, Stanislav Hrynus
Keywords
Related Articles
- EP ID EP281280
- DOI 10.23939/ujmems2017.02.047
- Views 92
- Downloads 0
Calculation of wave fields in a layered half-space with absorption based on the Thomson-Haskell method
This article is devoted to the development of calculation method of seismic waves on the free surface of a horizontally-layered half-space, which are perturbed by local sources. Previous obtained relations for scalar pot...
Nonlinear Analysis in Synthesis of the Resonant Vibro-Impact Systems
The paper considers differential equation of the vibro-impact resonance system with an asymmetric piecewise linear elastic characteristic. The time-instant of switching of elastic characteristic is determined on the basi...
Regulation of the phase-structural composition and metastability of austenite by alloying elements and parameters of tempering for increase wear-resistance of Fe-Cr-Mn deposited steel
It is shown that under the influence of alloying (Cr, Mn, C, Si, Ti, N, V) during electric arc hardfacing with a flux cored wire, as well as technological tempering parameters at temperatures of 300...700°C, the phase-st...
Two-mass Vibratory Conveyor-manipulator with Three-Component Electromagnetic Drive
Vibratory conveyor with three-component oscillations provides the opportunity to move the piece goods and details for any trajectory on a plane. Phase difference between independent horizontal (longitudinal or transverse...
Analysis of Modern Investigations of Vibratory Processes of Wheeled Vehicles
The history and modern tendencies of development of cushioning systems are analyzed in this paper. The development of mathematical modelling as a process is denoted, the methods and means are described and the necessary...