Perancangan Jaringan Indoor 4G LTE 1800 MHz Gedung Elektronika Politeknik Negeri Balikpapan Menggunakan Radiowave Propagation Simulator 5.4
Journal Title: Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering) - Year 2019, Vol 6, Issue 1
Abstract
Indoor area is an area that lacks a signal so that the signal attenuation continues to be problems that often occur. To overcome these problems need the support of a communication system that can include a signal in the room so that customers can keep communicate with smoothly. The need for application of indoor mobile communications system to support the outdoor system that can serve the entire mobile service users. This research discusses the planning of indoor femtocell LTE 4G network at the electronics building of the Balikpapan State Polytechnic is on the floor 1,2 and 3 with models Cost 231 multiwall indoor propagation. This design is simulated using 5.4 Software Radiowave Propagation Simulator (RPS). From the calculation results, the number of Femtocell Access Points (FAP) on each floor is 3, the placement of FAP in the middle part of each floor of the Electronics building. From the design results obtained on the 1st floor RSRP value of -32.18 dBm and SIR of 12.31 dB, for floors 2 RSRP -34.20 dBm and SIR of 13.52 dB, and floor 3 RSRP value of -33.32 dBm and SIR is 13.27 dB
Authors and Affiliations
Maria Ulfah, Nelsia Pither Tadung
Keywords
Related Articles
- EP ID EP549363
- DOI 10.33019/ecotipe.v6i1.950
- Views 59
- Downloads 0
Analisa Kinerja PAPR pada Sistem OWDM Menggunakan Wavelet Packet
In wireless communications, demand to provide high-speed data services with good performance raises new techniques to increase spectrum efficiency and improved signal quality due to frequency selective fading. OFDM is a...
Pengaruh Ketidakseimbangan Beban Terhadap Stabilitas Steady State
The stability of the electric power system is related to the balance of power in the system. When a power change occurs, the rotor will swing affecting the power angle, rotation speed, frequency and stability of the syst...
Penerapan Model K-Nearest Neighbors Dalam Klasifikasi Kebutuhan Daya Listrik Untuk masing-masing Daerah di Kota Lhokseumawe
Classification for electric power requirements for each region is very necessary in order to describe the power conditions needed This is very important for new customers to want to know the power provided, otherwise old...
Disain Pengendali Slip pada Haul Truck Mengunakan Metode Sliding Mode Controller
Changes in road conditions and friction wheel slip can result in the vehicle causing inconvenience to the user of the vehicle. To overcome this it is necessary to control the vehicle to slip in a state of minimal slip. I...
Disain Kontroler PI dengan Decoupling pada Sistem Kendali Level Coupled Tank
The problems on the Coupled Tank control level is the existence of disturbance in the flow that supplies tank would make unstability response, so it could happen the cross interaction between input and output. PI control...