Disain Pengendali Slip pada Haul Truck Mengunakan Metode Sliding Mode Controller
Journal Title: Jurnal Ecotipe (Electronic, Control, Telecommunication, Information, and Power Engineering) - Year 2014, Vol 1, Issue 2
Abstract
Changes in road conditions and friction wheel slip can result in the vehicle causing inconvenience to the user of the vehicle. To overcome this it is necessary to control the vehicle to slip in a state of minimal slip. In this study developed a method of control of the Direct Torque Control (DTC) in the three-phase induction motor is used as a vehicle to haul truck. By looking at the methods of the selected settings existing sliding mode method to overcome the problem of slip that occurs on the vehicle. DTC method is used to set the torque value directly, while the sliding mode method is used to regulate and minimize slippage that occurs in the vehicle. Simulations conducted in this research. The results of the simulation study shows that the method of sliding mode controller can minimize the slip according to setpoin 0.2. Slip the resulting values are in the range of provisions that slip occurs in a vehicle with a value of μ = 0 to μ = 1.
Authors and Affiliations
Ahmad Faizal
Keywords
Related Articles
- EP ID EP549239
- DOI 10.33019/ecotipe.v1i2.46
- Views 77
- Downloads 0
Rancang Bangun Unipolar PWM untuk Pengendalian Rangkaian H-Bridge Menggunakan Operational Amplifier
Unipolar PWM control technique carried out by comparing triangular wave with two control voltages. The resulting pulses are used to control H-Bridge circuit. The technique can be done by using the functions of the operat...
Perancangan Jaringan Indoor 4G LTE 1800 MHz Gedung Elektronika Politeknik Negeri Balikpapan Menggunakan Radiowave Propagation Simulator 5.4
Indoor area is an area that lacks a signal so that the signal attenuation continues to be problems that often occur. To overcome these problems need the support of a communication system that can include a signal in the...
Rancang Bangun Unipolar PWM Dilengkapi dengan Pengaturan Frekuensi Menggunakan Operational Amplifier
Pulse Width Modulation (PWM) is applied to power electronic circuits for the control of converter circuits. In order to obtain good performance, the frequency of the PWM pulse must be adjusted to the type and parameter o...
Disain Kontroler PI dengan Decoupling pada Sistem Kendali Level Coupled Tank
The problems on the Coupled Tank control level is the existence of disturbance in the flow that supplies tank would make unstability response, so it could happen the cross interaction between input and output. PI control...
Disain Pengendali Slip pada Haul Truck Mengunakan Metode Sliding Mode Controller
Changes in road conditions and friction wheel slip can result in the vehicle causing inconvenience to the user of the vehicle. To overcome this it is necessary to control the vehicle to slip in a state of minimal slip. I...