Problems and Solutions Regarding the Centrifugal Casting of Wire Sheave for Heavy Cranes
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2010, Vol 33, Issue 1
Abstract
The centrifugal casting of wire sheave is a technological method that ensures the important quality requirement, the continuity of the material in the active rolling zone of the sheave. However the centrifugal casting has some difficulties: the stability of the casting system, small productivity, gas permeability of the cast mould. The paper shows the problems induced by the centrifugal casting of these parts and the solutions for their solving.
Authors and Affiliations
Nicolae CANANAU, D. SCARLAT, G. FLOREA
Keywords
Related Articles
- EP ID EP635969
- DOI -
- Views 69
- Downloads 0
Characterisation of Niobium Carbide Coating Obtained by Chemical Vapour Deposition
The experiments conducted to obtain thin layer of carbide by the vapour chemical deposition method have followed an original path to make NbC directly in the working room thus avoiding the import of these hazardous subst...
Producing Bimetals by Direct Melting of the Bronze Machining Chips into Steel Supports
The bimetals can satisfy some requests of the working conditions impossible to be obtained using one single metallic material. The bimetallic pieces are obtained by the different production methods by covering of a steel...
A Test for Rapid Tribological Characterization of Bearing Steels
In this paper is a study the influence of the material and heat treatment on the changes of the fine structure parameters of the superficial layer of triboelements during the first cycles of rolling contact process. The...
Sanitary Silicone Used to Make Small Art Cast Parts
Also known as investment or precision casting process, the “lost wax process” was used in ancient times from China to Egypt to cast exquisite objects which are now displayed as artifacts in museums. The process is called...
Cu-Ag-Rear Metals for Wires: Processing and Characterisation
Cu based alloy microalloyed with rear metals (RM) (in our case, sample with Nb) for wires were prepared by two different techniques arc-melting and mechanical alloying. Microstructure characterisation was carried out by...